Gantner GAT NET.Lock 7000, Установка, настройка и эксплуатация

Страница: 20 / 40

GAT NET.Lock 7000 System
Mounting
20
HB_GAT-NETLOCK7000--EN_30
www.gantner.com
3.6.3 Steps for Mounting of the GAT NET.Lock 7000 at Metallic Doors
Please perform the following steps in order to mount the GAT NET.Lock 7000 at metallic doors.

Drill the 3 holes (3) for the GAT NET.Lock 7000 into the locker wall.
Attention: Position the 3 holes according to the information in the previous section "3.5.1. Important Measures
when Mounting the GAT NET.Lock 7000 and Bolt Set (Non-Metal Doors)"!

Plug-in the connection cable at the GAT NET.Lock 7000 (see "4. Electrical Connection").

Mount the GAT NET.Lock 7000 with 3 screws (3) on the inside locker wall.
Note: Use the right screws according to the type of locker material
Attention: The max. allowed tightening torque of the screws is 2 Nm.

On the inner wall of the locker door make the cut-out (63.2 x 68 mm) for the GAT NET.Lock Bolt Set 7200.

On the inner wall of the locker door drill the 4 holes (6) for mounting the GAT NET.Lock Bolt Set 7200.

On the outer wall of the locker door make the cut-out (68.2 x 94 mm) for the label carrier.

Mount the bolt set onto the inside wall of the locker door by using the 4 screws included in the scope of supply (Torx Ø
3.5 x 9.5 mm) as shown in Figure 3.8 on the previous page.
Note: Use the following screws (which are included in the scope of supply): Torx, Ø 3.5 mm, length 9.5 mm

Push the label carrier onto the outside wall of the locker door. The label carrier will hold in place with the lashes on
the label carrier - no screws are required.

Stick the front label onto the label carrier.
Note: A customer-specific front label can be used to cover the LED hole. A transparent field should be placed on
the label to show the LED light
Figure 3.9 - Label carrier with front label

Close the door to test, if the locker door can be closed easily and the door shackle inserts into the opening in the
GAT NET.Lock 7000.