57-1543
TOOLS NEEDED:
NOTE: FAILURE TO FOLLOW INSTALLATION INSTRUCTIONS AND NOT USING THE PROVIDED HARDWARE
MAY DAMAGE THE INTAKE TUBE, THROTTLE BODY AND ENGINE.
PARTS LIST:
Description
Qty. Part #
1. Turn off the ignition and disconnect the negative
battery cable.
NOTE: Disconnecting the negative battery
cable erases pre-programmed electronic
memories. Write down all memory settings be-
fore disconnecting the negative battery cable.
Some radios will require an anti-theft code to
be entered after the battery is reconnected. The
anti-theft code is typically supplied with your
owner’s manual. In the event your vehicles’
anti-theft code cannot be recovered, contact an
authorized dealership to obtain your vehicles
anti-theft code.
TO START:
2. Unlock the red locking tab on the air tempera-
ture sensor electrical connection, then depress the
locking lever and pull apart the temperature sensor
electrical connection
3. Loosen the hose clamp that secures the intake
tube to the throttle body and pull the intake tube off
the throttle body.
4. Disconnect the crankcase vent hose from the
valve cover port as shown.
5. Loosen and remove the airbox mounting bolt as
shown.
6. Lift the complete intake and air filter assembly to
remove it from the vehicle.
NOTE: K&N Engineering, Inc., recommends that
customers do not discard factory air intake.
7. Assembly the tube-mounting bracket and saddle
clamp as shown with the provided hardware.
8. Using the provided hardware, install the tube-
mounting bracket onto the engine at the threaded
hole in the cylinder head as shown.
9. Install the provided edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim may be
necessary.
A Hose Clamp #44
2
08560
B Hose; 3.0”ID X 1.75”L
1
08190
C Grommet
2
08064
D Intake Tube
1
087155
E Hose Clamp #48
1
08601
F Bolt; 6mm F/H/A
1
08376
G Saddle Bracket
1
078855
H Washer, conical, nylon, black
1
08180
I Washer; 1/4”ID X 5/8”OD, Flat
1
08275
J Nut; 6mm Nylock
1
07553
K Washer, 10mm Wave
1
08175
L Bolt; 10mm Hex
1
07702
M Bracket
1
010096
N Vent
1
08065
O Hose; 1/2”id X 7”L
1
08159
P Hose Clamp #56
2
08620
Q Hose; 3.5”ID X 2”L
1
08630
R Edge Trim #44
1
102486
S Heat Shield
1
074035
T Bolt; 6mm B/H/A
2
07730
U Fender Washer
2
08160
V Washer 1”x.300”x.100”,
2
21685
W Filter Adapter, #190
1
08806
X Hose Clamp #104
1
08697
Y Air Filter
1
RF-1048
Flat Blade Screwdriver
Ratchet
Extension
10mm Socket
17mm Socket
4mm Allen
DODGE / CHRYSLER
2009-10 Challenger SE
2006-10 Charger SE / Charger SXT
2005-10 300 Touring
2005-10 300 Limited
2005-08 Magnum SXT
V6-3.5L
10. Install the air filter adapter onto the heat shield
with the provided hardware as shown.
NOTE: Be sure to use the rubber gaskets pro-
vided.
