8
•
Plan your snow-throwing pattern to avoid snow discharge towards windows, walls, cars
etc., thus avoiding possible property damage or personal injury caused by a ricocheting
debris.
•
Never direct discharge at children, bystanders and pets or allow anyone in front of the
machine.
•
Do not overload machine capacity by attempting to clear snow at too fast of a rate….
Remember! Slow and steady operation is best to avoid clogs of snow being
impelled too rapidly.
•
Never operate this machine without good visibility or light. Always be sure of your footing
and keep a firm hold on the handles. Walk, never run.
•
Disengage power to the auger system (auger/impeller) by releasing the auger control
(lever) when transporting or not in use.
•
Never operate machine at high transport speeds on slippery surfaces. Look down and
behind and use care when backing up.
•
If the machine should start to vibrate abnormally, stop the engine, disconnect the spark plug
wire and ground it against the engine. Inspect thoroughly for damage. Repair any damage
before starting and operating.
•
Disengage all (drive and auger) control levers and stop engine before you leave the
operation position (behind the handles).
•
Wait until the auger /impeller comes to a complete stop before unclogging the chute
assembly, making any adjustments or inspections.
•
Never put your hand in the discharge or collector openings. Always use the clean-out tool
provided to unclog the discharge opening. Do not unclog chute assembly while engine is
running. Shut off engine and remain behind handles until all moving parts have stopped
before unclogging.
•
Use only attachments and accessories approved by the manufacturer (e.g. wheel weights,
tire chains, cabs etc.).
•
When staring engine, pull cord slowly until resistance is felt, then pull rapidly, Rapid
retraction of starter cord (kickback) will pull hand and arm toward engine faster then you can
let go. Broken bones, fractures, bruises or sprains could result.
•
If situations occur which are not covered in this manual, use care and good judgment
contact customer support for assistance.
MAINTENANCE & STORAGE
•
Never tamper with safety devices. Check their proper operation regularly. Refer to the
maintenance and adjustment sections of manual.
