Tennant 6100E, Инструкционный бюллетень

Страница: 1 / 6

IB 9018723 (04- 2019) 1
INSTRUCTION BULLETIN
No. 9018723
Machine: 6100E
Published: 04- 2019
Rev. 00
NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the
Parts List in the appropriate place in the machine manual for future
reference. Retaining the Parts List will make it easier to reorder
individual parts and will save the cost of ordering an entire kit.
NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
Installation instructions for kit number 9018722
SYNOPSIS:
This kit contains the parts needed to install the propel repair cable on 6100E sweepers.
Please follow step-by-step instructions.
SPECIAL TOOLS / CONSIDERATIONS: NONE
(Estimated time to complete: 1 hour)
PROTECT THE ENVIRONMENT
Please dispose of packaging materials, used machine components
such as batteries and fluids in an environmentally safe way according
to local waste disposal regulations.
Always remember to recycle.
PREPARATION:
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, and remove key.
1. Disconnect the battery cable from the
machine.
WARNING: Always disconnect battery
cables from machine before working on
electrical components.
2. Remove the left shroud from the machine and
set the shroud aside.
INSTALLATION:
1. Disconnect the main wire harness propel
leads from the controller M1 and M2
terminals. (Fig. 2/Fig. 3/Fig. 4)
2. Cut the connectors from the main wire
harness leads disconnected from the
controller and use electrical tape to secure the
leads back against the harness. Be sure all
exposed wire is completely covered with tape.
3. Disconnect the main wire harness from the
drive wheel assembly. (Fig. 2/Fig. 3/Fig. 5)
4. Cut the connectors from the main wire
harness leads disconnected from the drive
wheel assembly and use electrical tape to
secure the leads back against the harness.
Be sure all exposed wire is completely
covered with tape.
5. Connect the propel repair cable (1) to the
controller M1 and M2 terminals. (Fig. 2/
Fig. 3/Fig. 6)