13
III-
Assembling and adjusting Your Snow Thrower
Unpacking
Unpack the snow thrower and all its parts, and compare against the list below.
1.
Snow Thrower
2.
Discharge Chute Assembly
3.
Chute Rotation Handle
4.
(Qty. 2) one set of Skid Shoes with attaching hardware
5.
(Qty. 4) extra M6 Shear Pins and M6 Locknuts
6.
Speed control connection Rod.
ASSEMBLY
Your Snow Thrower will require some assembly. Please complete the following steps before using
your Snow Thrower.
WARNING: This snow thrower is heavy. Assembly procedures may require lifting
equipment utilizing two people.
Step 1: Installing the Upper Handle
1.
When installing the Upper Handle, please note that the Drive & Auger Cables will already
be pre-attached to Upper Handle.
2.
Attach Upper Handle using the Frame Handle Assembly Hardware (4 sets /Knob, Saddle
Washer, M8 Nut, T-Screw) for your Upper & Lower Handle connection.
3.
When attaching Assembly Hardware, make sure ALL cables are underneath the Frame
(Upper & Lower) Handles after installation as indicated in Figure 3. VERY
IMPORTANT!!!***
***Assembling
Drive & Auger
Cables over the top of the Frame
Handle will cause unnecessary tension in the cables, resulting in the Snow blower
Figure 1