EVO EXPERT Manual
89/105
SSID: this parameters set the SSID (identification name) of the wireless network in which
the viscometer has to link.
Channel[o]: This sets the channel in which the wireless network is located. The default
value is 0, which enables the automatic detection of the channels of communication.
This parameter should not be changed from the default state unless it is required.
SECURITY PARAMETERS
These parameters are only required depending on the security conditions of the wireless network.
WEP key[o]: This parameters sets the WEP security key to access the wireless network.
This key cannot be longer than 32 characters.
WEP number[o]: This parameter sets the WEP key number of the list configured.
These parameters should only be implemented if the wireless security is using WEP
encryption.
WPA passphrase[o]: This parameters sets the WPA/WPA2 security passphrase to access the
wireless network. The maximum possible length of the passphrase is 50 characters.
These parameters should only be implemented if the wireless security is using WPA
encryption.
Fig. 17 Pyramid chart that represents the wireless parameters in a hierarchical structure
Note:
It is strongly recommended to connect the viscometer to WiFi networks that use
the WPA2 security protocol
A.2.- Wireless configuration application (WiFi-Config)
A.2.1.- WiFi-Config application installation
