Fukuda 8000 Series, Руководство по обслуживанию

Страница: 37 / 230

xxi
Safety Precautions for Using the Equipment
 To clean the touch panel, use an optional cleaning cloth, eyeglass cleaning cloth, soft cotton cloth, or non-
woven cloth (pulp, rayon, polyethylene, etc.).
 Clean the equipment frequently so stains can be removed easily.

To prevent injury, it is recommended to wear gloves when cleaning the equipment.
 Pay attention not to allow chemical solution to enter the equipment or connectors.

Do not use organic solvents, thinner, toluene or benzene to avoid damaging the resin case.
 Do not polish the equipment with abrasive or chemical cleaner.

When disinfecting the entire room using a spray solution, pay close attention not to get any solution into the
equipment or connectors.

Use only neutral detergent to clean the equipment. The surface resin coating may damage, resulting in
discoloration, scratches, and malfunction.
Example:
chemical cloth, scrub brush, abrasive, polishing powder, hot water, volatile solvent and chemicals (cleanser,
thinner, benzine, benzol, and synthetic detergent for house and furniture), or sharp-edged tools
 Do not open the housing.

Do not allow alcohol or other liquids to enter the equipment.
 Replace the periodic replacement parts periodically as specified.
Wired Network (DS-LANII/ DS-LANIII)
 Do not connect unspecified device to the wired network.

Do not mix devices with DS-LANII and DS-LANIII setting in the same wired network. The network may cease
and proper monitoring may not be possible.
 If performing wired network transmission, configure the display so that the numeric data corresponded to the
waveform is displayed. If not, the displayed waveform or numeric data may not be transmitted.
 The default setting of bed ID is "000". If connected to a wired network with the bed ID unchanged, monitoring
on the central monitor will not be possible.
 When connecting to a wired network, make sure that there are no other bedside monitors with the same ID. If
there is more than one bedside monitor with the same bed ID, the duplicated bedside monitors cannot be
monitored on the central monitor.

When connected to the DS-LAN II network, set the bed ID in the range from "001" to "048" .
 When connected to the DS-LAN III network, set the bed ID in the range from "001" to "100" .

The alarms that can be notified to the central monitor depend on the model type and software version of the
central monitor. For details, refer to the operation manual of the central monitor.

There are following restrictions when connecting the DS-8500 System to the wired network.
 The BP measurement unit setting should be the same for all central monitors and bedside monitors. If the
setting is different among the monitors, data such as BP waveform, BP numeric data, NIBP numeric data,
NIBP list will not be transmitted. It will be treated as not measured data, and will not be displayed on the
central monitor. The alarm limit setup from the central monitor cannot be performed either.
 On the DS-LAN II network, the following arrhythmia alarms will not be transmitted.
TACHY, BRADY, COUPLET, PAUSE, TRIGEMINY, TRIPLET, EXT TACHY, EXT BRADY, R on T,
MULTIFORM, VENT RHYTHM, SVT, IRREGULAR RR, PROLONGED RR, S FREQUENT, S
COUPLET, VPC, SVPC, PACER NOT CAPTURE, PACE NOT PACING
 On the DS-LAN II network, arrhythmia alarm of "SLOW VT" will be transmitted as "VT" .
WARNING
CAUTION