Fukuda Denshi DS-7001, Руководство по обслуживанию

Страница: 48 / 151

Precautions for Installing the Equipment
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
The following environmental conditions should be observed when operating the DS-7001.
・
Surrounding Temperature : 10 ~ 40 ° C
・
Relative Humidity : 30 ~ 85% (non-condensing)
The DS-7001 is intended for patient monitoring in the general ward, ICU, CCU, OR and during
in-hospital transportation. Do not use in the MRI environment, inside hyperbaric chamber,
flammable anesthetic gas and outside hospital (including inside ambulance).
The power source should fulfill the following condition.
・
Always use a hospital grade, 3 prong grounded power cable.
・
Verify the power voltage and frequency before connecting to an AC power source.
・
Use the power source that can provide adequate power to the device.
Pay attention when installing or storing the device. Do not install or store in the following
locations.
・
Where chemicals are stored or gas may generate
・
Where the equipment will be subject to splashing water or humidity from a nebulizer or
vapolizer
・
Where the equipment will be subject to direct sunlight
・
Unstable place with inclination, vibration, or shock
Proper ventilation is required to cool the device.
・
Do not cover the vent hole located at the rear side of the monitor.
A minimum space of 3 cm is required between the monitor and the wall.
・
If the monitor is embedded in a wall or surrounded by a wall, a minimum space of 3 cm is
required above the monitor.
W ARNI NG
l Do not cover the vent hole located at the rear side of the monitor.
l
If this device is used under adverse environmental conditions, not
only that the device cannot deliver its maximum performance, the
device may be damaged and safety cannot be ensured.
3 － 2