Fujitsu ETERNUS CS800, Руководство пользователя

Страница: 273 / 604

Additional Information
l
Before you can add a replication target, you must add the ETERNUS CS800 to the list of
allowed replication sources on the target ETERNUS CS800 (see
"Adding a Replication
Source" on page 278 ).
l
To add a new target when two targets are already configured, first delete one target (see
"Deleting a Replication Target" on page 276 ). Then add the new target.
l
For more information about enabling and scheduling replication for a share or partition,
see
"Replication Send" on page 371 .
To add a replication target:
1. Under Target System , click Add .
The Add Target Host window displays (see "Add Target Host" on page 273 ).
Figure 178: Add Target Host
2. In the Target Hostname or IP box, enter the hostname or IP address of the system that
will receive the replicated data.
When entering IP addresses, never use an address that is in a reserved IP address
range. To see a list of reserved IP address ranges, click the quick tip icon
[?] located
near the IP address field.
To use hostname format, you must specify at least one DNS IP address on the Network
page (see "Network" on page 319 ).
3. In the Encryption drop-down box, select the type of encryption to use when sending
replication data to the target system ( None , 128-bit , or 256-bit ).
CAUTION!
For encryption, select None or 128-bit if you are sending data to a ETERNUS
CS800 running a system software version prior to ETERNUS CS800 2.1.1
Software.
AES encryption options are available only if the Data-in-Flight license is
installed.
4. In the Source IP box, enter the IP address that is used to uniquely identify the source
ETERNUS CS800 273
10 Configuration