Fujitsu Siemens Computers FUTRO C, Руководство по эксплуатации

Страница: 46 / 70

System expansions
38 A26361-K679-Z120-1-7619, edition 2
► Replace the front USB audio interface cage into the opening on the front panel of the device
and secure it with the screw.
► Install the board holder (see "Installing the board holder").
► Close the casing (see "Closing the casing").
i
So that the riser card is sufficiently secured in case of further system expansions, you
must reinstall the board holder after installing the riser card before you make further
changes to the riser card.
Removing the riser card with a DVI port
► Open the casing (see "Opening the casing").
► Remove the board holder (see "Removing the board holder").
► Remove the front USB audio interface on the device front panel by loosening the screw and
then removing the cage.
► Remove the ventilation duct from the casing.
► Unplug the power supply cable of the processor fan from the main board. See technical manual
for the mainboard.
► Press down the mainboard bracket (spring) located on the casing bottom on the right-hand
edge of the mainboard and push the mainboard to the front of the casing.
a
► Pull the riser card upward out of the slot.
► Slide the main board back toward the
casing rear panel into its original position
until the main board spring catch latches
up and secures the main board.
► Connect the power supply cable of the processor fan to the connector on the mainboard. See
technical manual for the mainboard.
► Place the ventilation duct in the casing.
► Replace the front USB audio interface cage into the opening on the front panel of the device
and secure it with the screw.
► Close the casing (see "Closing the casing").