FTS LT1-CELL-VZ, Руководство оператора

Страница: 52 / 66

700- LT1-Man Rev 8 09 Feb 2021 Page 46/60
A.3
LED FAULT INDICATIONS
LED Status Indicators:

= On

= Off N/A –not applicable (can be on, off, or blinking)

=
Blinking once every 10 seconds

= Blinking every second
Normal Operation:
Indicates Comment

  
System OK
This is the state when power is first applied once all
connections are made or when initially connecting to the
station using the FTS360 Config App (unit operating normally,
no faults).

  
Low Power
Mode
Sending a command (such as the connect, add sensor, or any
editing command) will illuminate the lights as indicated
above.
Faults:
Indicates
Solution
   
No power to the
LT1
1) Check battery connections
2) Confirm wire connections to the terminal block and
terminal block firmly seated
Battery fully
discharged
1) Replace battery
2) If being used with a solar panel and regulator, check
connections to ensure battery being charged
  N/A N/A
CELL:
No cellular
connection
It can take 1-20 minutes (or longer) to get an initial
cellular connection based on numerous factors such as
geographical location, carrier, if the signal has to roam
etc. If after a reasonable time based on the above
factors, the cellular LED is still blinking try the following:
1) Check Cellular antenna connection
2) Confirm SIM card is inserted correctly
3) Confirm correct APN input (from FTS360 Config App
dashboard, select “Cellular” and view APN information.
3) SIM card not activated. Call cell plan provider to
activate SIM card.
  N/A N/A
GOES/
Meteosat:
No transmission
possible
1) No GPS time fix: Wait for GPS time fix
2) Invalid configuration so transmission not possible.
Review configuration
 N/A
N/A

Unable to obtain
a GPS fix
1) Check GPS antenna connection
2) GPS satellite signals may be blocked or weak
a) Check for physical obstructions such as cliff faces
and move GPS antenna to unobstructed area
3) Check Cellular connections (GPS cannot get a fix if
cellular module cannot connect to the base station)

N/A

N/A
Before you
connect:
Someone else is
connected
1) If possible, request the other party to disconnect; or
2) Power cycle the LT1 (remove and replace the power
terminal block) to disconnect active BLE connections.
This will terminate all other BLE connections.
For > 5 minutes