FSL3D Pegasus Touch, Руководство пользователя

Страница: 13 / 43

13

Rubber mallet (to tap the steel pa int scraper) , e.g. Home Depot
#31030
Part finish ing :

1-2L glass conta in er for soaking finished parts in IPA , e. g. Amazon
B0000CFG5I

2.5 ounce spra y bo ttle , e.g. Amazon B000NJHNLW

Tongs, e.g. Amazon B00004OCK1

Tweeze rs, e.g . Amazon B00BG8W W 2Y
Unpacking:

Un wrap machine a nd inspect for dam ages

Cut zip tie s hold ing the vat holde r
Setup
Make su re that you r printe r is on a le vel su rface, a wa y from direct
sunlight, and in a temperature -contro lled location. After removing a ll
accesso rie s from the interior of the machine and ensu rin g it is clean, it is
time to connect to you r machine.
1. Connect the Ethe rn et port of the machine to a free port on you r
internet route r usin g the supplied Ethe rnet cab le .
2. Ethernet is the p referred interface , but USB PC connectio n (requ ire s
mini-USB cab le, no t supplied ) and W iFi (requires dong le, not
supplied ) a re also supported. You ma y a lso load job s via USB ke y.
Refer to instruction s at the use r forums at
http://fsl3d.com/forums
for more informatio n.
3. Plug the po we r ad a pter into a con ven ient mains po we r ou tlet.
4. Plug the DC ba rre l connector into the powe r po rt on the machine.
5. The machine should boot with in 90 se conds.
The Pegasus Touch can get print data from one of five so urces:
1. Ove r Ethe rnet from the Retina Create job preparation and machine
management software.
2. From a USB flash d rive .
3. Ove r W iFi (require s optional Tenda W 311M USB W iFi dongle, not
supplied. Amazon B006GCYAOS)
4. Ove r USB cab le (re quires mini-USB ca ble, not supp lied , e .g.
Amazon B001TH7GUK )
5. Directly from the FSL3D Mode l Ma rke tplace.