4.8.6 Feed system - Cyclone 1 (4/8x toggle)
System menu
Feed system
Cyclone 1 / 2
1
2
3
4
5
6
Number
Description
1
Overview of the maximum available suction probes. If the RS4 suction system is selected, only four positions
are shown. Tap the respective suction point to open a window in which various functions can be called up.
2
Selected suction point should be started by the selection unit probes. The area of the suction point flashes
alternately grey/green until the desired position is reached.
3
Selected suction point is available.
4
If the selected suction point is generally not in use or should not be used due to a problem (suction hose,
blockage by pellets, etc.) the suction point can be locked by tapping on this area.
5, 6
Buttons for switching between cyclone 1 and cyclone 2.
Cyclone active
▪ NO: Cyclone on the vacuum discharge system is not in
use.
▪ YES: Cyclone on the vacuum discharge system is in
use.
Maximum time until switching of probe
Prerequisite: Feed system 4 probe switch or 8 probe
switch
Time period, during which the cyclone must reach a fill
level of 100% from a probe. If this time is exceeded, the
change-over unit automatically changes to the next probe.
If all probes are started and the fill level of 100% in the
cyclone is not reached, an error message appears on the
display.
Probe suction reversal for
Prerequisite: RS4 / RS8 pellet suction system
Before switching to the next probe, the probe that was last
used is back-flushed for the time set.
Parameters overview
4
Feed system
Service manual Lambdatronic H 3200 for wood chip boiler | B1480721_en
77
