background image

• Children and adults should be alerted to the hazard of high surface

temperature and should stay away to avoid burns or clothing ignition.

• Young children should be carefully supervised when they are in the

same room with the heater.

• Do not place clothing or other flammable material on or near the

heater.

• Any safety screen or guard removed for servicing the heater must be

replaced prior to operating the heater.

• Installation and repair should be done by a qualified service person.

The heater should be inspected before use and at least annually by a

professional service person. More frequent cleaning may be required

due to excessive lint from carpeting, bedding material, etc. It is

important that control compartments, burners and circulating air

passageways of the heater be kept clean.

• Allow the heater to cool before servicing. Always shut off the gas to

the heater while performing service work.

• The installation must conform with local codes or, in the absence of

local codes with the National Fuel Gas Code, ANSI Z223.1.

• The heater and its individual shut-off valve must be disconnected

from the gas supply piping system while performing any tests of the

gas supply piping system at pressures in excess of 1/2 psig.

• The heater must be isolated from the gas supply piping system by

closing its individual manual shut-off valve during any pressure

testing of the gas supply piping system at test pressures equal to or

less than 1/2 psig.

• Keep heater area clear and free from combustible materials, gasoline

and other flammable vapors and liquids.

• Do not use this heater if any part has been under water. Immediately

call a qualified service technician to inspect the room heater and to

replace any part of the control system and any gas control which has

been under water.

• Input ratings are shown in BTU per hour and are for elevations up to

4,800 feet. Do not install this heater at an elevation above 4,800 feet if

the gas supply has not been derated for that elevation. Consult your

local gas supplier. (For operation at elevations above 4,800 feet,

equipment ratings shall be reduced at the rate of 4 percent for each

1,000 feet above sea level before selecting appropriately sized

equipment.)

• Ensure that the heater is clean when operating. Excessive dust

accumulation on the burner will increase the amount of carbon

monoxide formation and could lead to carbon monoxide poisoning

and/or death.

• This appliance is intended for supplemental heating

Adhere to all local codes or in their absence the latest edition of The

National Fuel Gas Code ANSI Z223.1 or NFPA54 which can be obtained

from The American National Standards Institute, Inc. (1430 Broadway, New

York, NY, 10018) or National Fire Protection Association, Inc.

(Batterymarch Park, Quincy, MA, 02269). 

Seller of unvented propane or natural gas fired supplemental room heaters

shall provide to each purchaser a copy of 527 CMR 30 upon sale of the

unit.

This Focal Point Unvented Gas Room Heater is certified by OMNI-Test

Laboratories, Inc to ANSI Z21.11.2-2004b standard.

This heater shall not be installed in a confined space or unusually tight

construction unless provisions are provided  for adequate combustion and

ventilation air. 

The 

National Fuel Gas Code, ANSI Z223.1/NFPA 54

defines a confined

space as a space whose volume is less than 50 ft 

3

per 1,000 BTU/Hr (4.8

m

3

per kW) of the aggregate input rating of all appliances installed in that

space and an unconfined space as a space whose volume is not less than

50 ft 

3

per 1,000 BTU/Hr (4.8 m

3

per kW) of the aggregate input rating of all

appliances installed in that space. 

Rooms communicating directly with the space in which the appliances are

installed, through openings not furnished with doors, are considered a part

of the unconfined space.

Unusually tight construction is defined as construction where:

a. 

wall and ceilings exposed to the outside atmosphere have a continuous

water vapor retarder with a rating of one perm or less with openings

gasketed or sealed, and

b. 

weather stripping has been added on operable windows and doors, and 

c. 

caulking or sealants are applied to areas such as joints around window

and door frames, between sole plates and floors, between wallceiling joints,

between wall panels, at penetrations for plumbing, electrical, and gas lines,

and at other openings.

Use the following equations to determine if you have a confined or
unconfined space.

3

5.0 CODES

6.0 COMBUSTION AND VENTILATION AIR

4.0 IMPORTANT SAFETY INFORMATION (continued)

Determine the volume of space — ft 

3

.

Length x Width x Height = _____ ft 

3

(Include adjoining rooms with doorless passageways or ventilation

grills between rooms.)

Example:

24' (L) x 16' (W) x 8' (H) = 3072 ft 

3

Divide the volume of space by 50 ft 

3

to determine the maximum

BTU/Hr the space can support.

______ (volume of space – ft 

3

)/ 50 ft 

3

=

(Maximum BTU/Hr the space can support)

Example:

3072 ft 3 / 50 ft 3 = 61.44

or 61,440 BTU/Hr the space can support.

Add the BTU/Hr of all the fuel burning appliances in the space.

Vent-Free heater 

_______ BTU/Hr

Gas appliance #1*  _______ BTU/Hr

Gas appliance #2 +  _______ BTU/Hr

Gas appliance #3 +  _______ BTU/Hr

Total =

_______ BTU/Hr

Example:

Vent-free heater #1               9,000  

BTU/Hr

Vent-free heater #2              23,000  

BTU/Hr

Gas appliance #1                 35,000 

BTU/Hr

(water heater)

Total =     67,000  BTU/Hr

* Do not include direct-vent gas appliances. Direct-vent is sealed

combustion and draws combustion air from the outdoors.

1.

2.

3.

Содержание RADIUM F500080























Отзывы: