2
This appliance is a high efficiency, unvented, flame effect gas heater. It
provides radiant and convected warmth both efficiently and safely
utilizing the latest type catalytic convertor burner technology. The
appliance does not require a flue system of any type as the catalytic
converter cleans the flue products to provide a complete combustion
system, which is intrinsically safe.
These heaters are fitted with a specially designed pilot utilizing an
oxygen depletion sensor (ODS) which responds to the amount of
oxygen available in the room and shuts the heater off before the oxygen
level drops below 18%. The pilot can be relit only when fresh air is
available. Refer to the Combustion and Ventilation Air section.
The appliance is designed to fit various types of situations as listed in
the Installation Requirements.
This appliance is factory set for operation on the gas type, and at the
pressure stated on the appliance rating plate.
On initial light up of a new appliance, the ‘newness’ will burn off within
the first few hours of operation. During this period some smoke may be
emitted from outlet grille, this should be no cause for concern.
Accordingly, the room should be well ventilated with all windows and
doors open during this period.
Read all these instructions before commencing installation.
All instructions must be handed to the user for safekeeping.
QUANTITY
DESCRIPTION
1
Firebox, burner & curved rear frame assembly
1
Installation and operating instructions
1
Glass facia panel assembly
1
Screw and wall plug pack
1
Rubber grommet
1
Fitting template
1
Wall mounting plate
STATE OF MASSACHUSETTS: THE INSTALLATION MUST BE MADE
BY A LICENSED PLUMBER OR GAS FITTER IN THE
COMMONWEALTH OF MASSACHUSETTS.
Carbon Monoxide Poisoning: Early signs of carbon monoxide
poisoning are similar to the flu with headaches, dizziness and/or
nausea. If you have these signs, obtain fresh air immediately. Turn off
the gas supply to the appliance and have it serviced by a qualified
professional, as it may not be operating correctly.
Section
Contents
Page No.
1.0
General Information
2
2.0
Inventory
2
3.0
Appliance Data
2
4.0
Important Safety Information
2
5.0
Codes
3
6.0
Combustion and Ventilation Air
3
7.0
Site Requirements
4
8.0
Preparing the Appliance
5
9.0
Mounting the Appliance
5
10.0
Checking the Burner
5
11.0
Connecting a Gas Line
5
12.0
Checking the Gas Connections
6
13.0
Gas Pressure Check
6
14.0
Spark Gap
6
15.0
Fitting the Glass Facia
6
16.0
Briefing the customer
7
17.0
Servicing
7
18.0
Servicing the Burner
7
19.0
Pilot Assembly
8
20.0
Catalysts
8
21.0
Testing for Firebox Leakage
8
22.0
Cleaning
8
23.0
Lighting Instructions
9
24.0
To Turn off gas to Appliance
9
25.0
Troubleshooting Guide
10
26.0
Shortlist of Spare Parts
10
27.0
Positioning of field assembled parts
11
WARNING: FAILURE TO COMPLY WITH THE INSTALLATION
AND OPERATING INSTRUCTIONS PROVIDED IN THIS
DOCUMENT WILL RESULT IN AN IMPROPERLY INSTALLED
AND OPERATING APPLIANCE, VOIDING ITS WARRANTY.
ANY CHANGE TO THIS APPLIANCE AND/OR ITS
OPERATING CONTROLS IS DANGEROUS. IMPROPER
INSTALLATION OR USE OF THIS APPLIANCE CAN CAUSE
SERIOUS INJURY OR DEATH FROM FIRE, BURNS,
EXPLOSION OR CARBON MONOXIDE POISONING.
1.0 GENERAL INFORMATION
2.0 INVENTORY
4.0 IMPORTANT SAFETY INFORMATION
TABLE OF CONTENTS
3.0 APPLIANCE DATA
Gas Type
Natural Gas
Gas inlet pressure Maximum
10.5” w.c.
Minimum
6” w.c.
Regulator Pressure Setting
5” w.c.
Max Energy Input
8,870 BTU/hour
Min Energy Input
5,110 BTU/hour
Pilot Energy Input
560 BTU/hour
Burner (Manifold) Pressure
High
3.6” w.c. (+/-0.3” w.c.) Hot
3.5” w.c. (+/-0.3” w.c.) Cold
Low
1.2” w.c. (+/-0.3” w.c.) Hot
1.1” w.c. (+/-0.3” w.c.) Cold
Main burner flow restrictor
Stereo 1.45mm (1/4” BSP)
Oxypilot
SIT/Bray 9082
Gas Inlet Connection
3/8” NPT at regulator
Ignition
Piezo spark
Spark Gap
1/8” - 3/16”
Please see Data Plate affixed to appliance for current data.
This appliance is for use only with the gas type, and at the pressure
stated on the appliance Data Plate.
IMPORTANT: READ AND UNDERSTAND THESE
INSTRUCTIONS COMPLETELY BEFORE INSTALLING OR
OPERATING YOUR UNVENTED ROOM HEATER.
WARNING: FAILURE TO KEEP THE PRIMARY AIR
OPENING(S) OF THE BURNER(S) CLEAN MAY RESULT IN
SOOTING AND PROPERTY DAMAGE.
