Flyer Mountain, Оригинальное руководство пользователя

Страница: 323 / 412

72
Activate the light by pressing the light button;
switch between low and high beam (if available)
by pressing the light button again. Switch off the
light by pressing and holding the light button (at
least 1 second) . Switching between low beam/
daytime running light: Automatic switching based
on the integrated light sensor .
In their default factory configuration, FLYER
Uproc e-mountainbikes are classified as sports
equipment . They are not compliant with StVZO
(the German regulations authorising the use of
vehicles for road traffic) and therefore are not au -
thorised for use on roads . If you wish to use your
FLYER e-mountainbike on public roads, you will
need to ask your FLYER dealer to fit the neces -
sary equipment (light, reflectors etc).
Passive lighting (reflectors) is included with your
purchase. Reflectors are no substitute for the
necessary lights, but will significantly improve vi -
sibility at dawn and dusk .
When attaching the reflectors, please be aware
of the following:
• Make sure that the reflectors are fitted
correctly and that they are not cover-
ed by other components, clothes or
accessories .
• Before every journey, check that the
reflectors are properly and securely
fastened, clean and free of damage .
• Do not make modifications to the re-
flectors . Replace defective reflectors
or have them repaired .
If you wish to use your FLYER mountainbike on
public roads, you will need to ask your FLYER de-
aler to fit the necessary active equipment (head -
light and rear light) . Pay attention to the general
information on lighting in the section below .
FLYER with pedal assist up to 25 km/h and
crossover bikes
Basic settings: Switch off the light by pressing the
light button . Switch the light back on by pressing
the light button again .
Switching between low beam/daytime running
light: Automatic switching based on the integrated
light sensor .
General information on lighting
Do not use the high beam when vehicles
are coming the other way . You should
also avoid using your high beam in traffic
queues, in built-up areas or around pe-
destrians .
If your FLYER has a brake light, check it
regularly to make sure that it is working
properly and consult your FLYER spe-
cialist retailer if you are unsure or have
a problem .
The daytime running light is only to be
used for signalling to other road uses
and is switched on and off independent -
ly by a sensor .
Clean your reflectors and lights on a reg -
ular basis . Warm water with cleaning
fluid or washing up liquid is suitable
here .
The lighting system is a safety-related
component and it is vital that it is in prop-
er working condition . Check that it is
working correctly and safely at regular
intervals .
Only allow authorised FLYER specialist
retailers to perform checks and servicing
work after failures or temporary prob-
lems!
19. Mudguard
Some mudguard models are fitted with a safety
fastening in case an object jams between the
mudguard and the tyre .
This releases the mudguard from its holder to
prevent a fall .
You must stop riding immediately if a foreign body
is trapped between the tyre and the mudguard .
Remove the foreign object before beginning to
ride again . Otherwise, there is a risk of falls and
serious injuries .
You may under no circumstances ride
with a loose mudguard strut, as the strut
may jam in the wheel and block it . The
loose ends of the holders may lead to
serious accidents .
Damaged mudguards must be replaced by a
FLYER specialist retailer before you ride again .
You should also regularly check whether the brac-
es are fixed securely in the safety releases.