28
Floataway Installation Manual 230v 50Hz Tranquility 2017 - v3
Other possible alarms are for over high temperature
and low water. You will see the flashing lights but no
sound. These will not cancel until corrected. There
are further messages for low reservoir and some other
options.
Music Settings :
Use the menu button; scroll to global settings, then
to music.
There are three choices : on, off or fade. Use the up
and down buttons to select, and then press OK .
On The music will play continuously
throughout the session, but stops at the end
of the session provided that the music source is
continuous.
Fade The music will start with the session and fades
down to silence after the programmed number
of minutes. At the end of the session the music
will fade up again two minutes before the end.
Off The Music is off, but will fade in at the end of
the float session to indicate the end.
Now you must use the back button to exit the menu
and you are prompted to save the change, so press
OK again.
End of Float Session
When the session stops either automatically or when
you press the end session button, there is a sequence
of events:
First, the music fades up (if it was off/faded)
Then the light comes on
After two minutes the door opens (Tranquility only)
Then there is the “bing bong” sounder to indicate
the end of session.
Finally, after another two minutes, the pump will
start.
The status screen above tells you the current session
count and also the number of sessions since last time
the filter was changed. Actually this is since the filter
top was last opened, but usually that is to change a
filter. The total session count is non-reset
and is intended to keep a record for audit purposes.
