18
Floataway Installation Manual 230v 50Hz Tranquility 2017 - v3
The under water lights
The under water light/s are a combination RGB, warm
white and cool white LED unit. The lamp has a 12v supply
and a remote control. The remote can adjust the colour and
brightness of each lamp individually or all at the same time.
Once the lamp colour and brightness has been adjusted to
your room. the lamp will keep those settings, turning on/off
with the float session control, remembering the settings you
programmed.
The lamps are coded in the factory to your remote, each
lamp uses a different “zone” number. you can reprogram
these numbers if you choose.
To fit, unscrew the two clamp bolts by hand.
Remove all packaging and carefully position the lamp into
the lamp housing. You are now ready to re-fit the lamp
Carefully slide the lamp into the holder and re-tighten the
two bolts by hand to secure the lamp.
The remote for the lamps uses 2.4G Wi-Fi, it needs to be in
range to control the lamps, the lamps can only be adjusted
when they are ON.
To adjust ALL the lamps at once, use the O/I buttons above
the colour wheel to turn the lamps off/on then adjust the
colour/brightness of the lamps together.
To adjust individual lamps, press one of the “1-4 zone” O/I
button at the bottom of the remote, then adjust the colour/
brightness of that lamp.
To adjust the the colour/white balance use the RGB slider
To adjust the the brightness use the brightness slider
To adjust the the warm/cool white balance use the blue/
yellow slider
To select the Mode to have multi colour fade sequence
etc, use the M button, and then adjust the speed with +/-
buttons.
To LINK a lamp to a zone : turn lamp OFF, and then ON,
press chosen Zone button 3 times within 10 sec.
To UN-LINK a lamp to a zone : turn lamp OFF, and then
ON, press corresponding Zone button 5 times within 10
sec.
