Flavor Burst TS 80BLD, Руководство пользователя

Страница: 55 / 96

54
Installing the Blending System and
Suspension Bracket
The Suspension Bracket helps stabilize the
Blending Assembly on the freezer. When
properly installed on the freezer, the Bracket
should hold the Blending Assembly level
horizontally, with the Blending Head lined up
directly under the Spout Adapter. The
Suspension Bracket is adjustable to fit many
common freezer models. Additional
Suspension Bracket styles are available for
other freezer models through your distributor.
The Blending Assembly can be mounted to
either side of the freezer spout. The 9-Tube
Assembly may also come from either side,
regardless of the Blending Assembly’s position.
However, on single freezer models, the
following is the recommended.
RECOMMENDED POSITIONING:
(A) When possible, install the Blending
Assembly on the opposite side of the 9-
Tube Assembly’s placement.
Placing
the Drive Motor end of the assembly
opposite from the 9-Tube Assembly
makes it easier to attach and remove
the 9-Tube Assembly when cleaning.
(B) Install the Blending Assembly to the
right side of the freezer door and install
the 9-Tube Assembly on the left side of
the freezer. Typically, the intake vents
are on the left side and the outtake
vents are on the right. If the 9-Tube
Assembly is installed on the right side,
the outtake vents could warm the syrup
and melt the soft serve product when
served. Installing the 9-Tube Assembly
on the intake vent side (left) will keep
the syrup cool and product consistent.
1. Determine how the Blending Assembly will
be positioned on the freezer. When
possible, follow the recommended position
outlined above.
26047
2. Rearrange the Suspension Bracket
assembly so that it is placed on the outer
side of the Blending Assembly, with the
open end of the bracket hook facing toward
the center of the freezer. Ensure all parts
are assembled in the proper order.
26086
NOTE:
THE UPPER BRACKET SHOULD
ALWAYS BE INSTALLED TO THE OUTSIDE
OF THE BRACKET BASE, WITH THE SPRING
WASHER BETWEEN THE BRACKET PIECES
AND THE NYLON WASHER BETWEEN THE
UPPER BRACKET AND THE THUMB SCREW.
NOTE:
INSTALL THE THUMB SCREW FROM
THE OUTSIDE OF THE BRACKET
ASSEMBLY SO THAT ADJUSTMENTS CAN
BE MADE EASILY IF NEEDED.
NOTE:
THE HOOK OF THE UPPER
BRACKET SHOULD FACE TOWARDS THE
CENTER OF THE FREEZER.
NOTE:
THE DESIGN OF THE BRACKET MAY
VARY, HOWEVER ASSEMBLY
INSTRUCTIONS STILL APPLY.
3. Hang the Suspension Bracket on the lower
door post and install the Blending Assembly
on the preferred side of the freezer. Install
the Blending Head locking ring fully over the
Spout Adapter so that the locking collar
covers the tabs on the Adapter and rotate
the locking collar to secure.
26042