Flavor Burst TS 80BLD, Руководство пользователя

Страница: 39 / 96

38
11. Press the WATER / SYRUP FLUSH key.
Back Done
Maintenance
Setup Options
Prime Syrup Pump
Serving Counter
Timing Settings
Water/Syrup Flush
Menu Setup
Adjust Dispense Rate
26544
12. The system is now in the Water / Syrup
Flush mode. Press the flavor of the line you
wish to flush.
Done
Back Water/Syrup Flush
Chocolate Swirl
Strawberry
Butter Pecan
Classic Cherry
Banana Ripple
Green Apple
Blue Goo
Purple Grape
Injector Flush
26580
13. The next screen will remind you to connect
the Pump Flush Adapter (or Flush Line) to
the flavor connector, which you should have
already done in Step 8. It will also show a
START / STOP key.
Back Water/Syrup Flush
Connect Water Flush
Line to flavor connector
P2 - 1
and place container under spout
to collect flushed syrup
Start/Stop
26581
14. To flush the syrup line, press the START /
STOP key. Sanitizer solution will begin to
clear out the syrup line.
Chocolate
26255
15. Once the flush process has completed the
full 15 minute flush, press the BACK key to
return to the Water / Syrup Flush menu
screen. Disconnect the Pump Flush
Adapter.
Back
26509
16. Repeat Steps 8, 12-15 for the second line,
then the third, and so on until all the lines
have been flushed. While the lines are
flushing, proceed to “Phase 3: Clean” to
make the most of your time.
NOTE:
WATER / SYRUP FLUSH WILL
CONTINUE FOR 15 MINUTES. YOU MAY
CANCEL AT ANY TIME BY TOUCHING THE
FLAVOR KEY AGAIN. HOWEVER, THE
SYSTEM
MUST COMPLETE A FULL 15
MINUTE FLUSH PROCESS FOR EACH
SYRUP LINE
IN ORDER TO COMPLY WITH
SANITATION GUIDELINES.
17. When all lines have been flushed,
disconnect the Pump Flush Adapter and
return to the main menu by pressing the
BACK key on each screen.
Back
26509