Flavor Burst TS 80BLD, Руководство пользователя

Страница: 51 / 96

50
NOTE:
YOUR HANDS SHOULD BE CLEANED
AND SANITIZED BEFORE YOU PERFORM
THE FOLLOWING PROCEDURES.
NOTE:
INSPECT ALL WEAR ITEMS AND
REPLACE IF NECESSARY.
NOTE:
THE FOLLOWING PROCEDURES
REQUIRE APPROVED, SERVICEABLE AND
SANITIZED TOOLS AND BRUSHES.
CONTACT YOUR LOCAL DISTRIBUTOR FOR
RECOMMENDED SUPPLIES.
NOTE:
USE AN APPROVED CLEANER AND
SANITIZER FOR THE FOLLOWING
PROCEDURES. REFER TO
MANUFACTURER’S INSTRUCTIONS FOR
PROPER PREPARATIONS OF THESE
CLEANING AGENTS.
NOTE:
THE SYSTEM IS NOT TO BE USED
BY PERSONS (INCLUDING CHILDREN) WITH
REDUCED PHYSICAL, SENSORY OR
MENTAL CAPABILITIES, OR LACK OF
EXPERIENCE AND KNOWLEDGE, UNLESS
THEY HAVE BEEN GIVEN SUPERVISION OR
INSTRUCTION.
NOTE:
CHILDREN ARE TO BE SUPERVISED
WHEN USING THE SYSTEM AND SHALL
NOT PLAY WITH THE SYSTEM.
NOTE:
INSTALL THE SYSTEM WHERE
AMBIENT TEMPERATURES ARE BETWEEN
60 AND 80 DEGREES FAHRENHEIT FOR
CORRECT OPERATION.
NOTE:
INSTALL THE SYSTEM IN A
LOCATION WHERE ITS USE AND
MAINTENANCE IS RESTRICTED TO
TRAINED PERSONNEL.
Installing the Touchscreen and Mounting
Bracket
The Touchscreen is the control unit for the
Flavor Burst
®
system. Normal operating
functions are performed using the Touchscreen
and the freezer draw handle. The Touchscreen
is mounted to the top of the freezer with the
Touchscreen Mounting Bracket.
1. Clean, rinse and dry the top surface of the
freezer between the front edge and the
hopper. This area is where the
Touchscreen will be mounted.
Detergent
CLEAN
Water
RINSE
DRY
26124
NOTE:
THE SURFACE MUST BE FREE
FROM DUST AND OILS OR THE ADHESIVE
WILL NOT CURE PROPERLY.
2. Place the assembled Touchscreen and
bracket onto the top edge of the freezer,
centered above the draw-handle. The
bottom plate of the bracket should sit fully
on the top surface of the freezer between
the front edge and the hopper cover. Use a
pencil to mark around the plate.
CENTER
26123
EQUIPMENT SETUP