Fisher Scientific accuSpin 3, Руководство по эксплуатации

Страница: 57 / 82

Troubleshooting
53
Error Symptom Possible causes and corrective measures
Message "rotor " appears
in display.
Rotor decelerates with
delayed deceleration.
Set speed exceeds permissible maximum speed for the
rotor.
(The same holds for RCF setting)
A) For about 15 sec. the display shows alternately "rotor" and
the maximum permissible speed or RCF for the installed,
after the rotor identification. Within this period, it is
possible to accept this value by again pressing the "start"
key. The centrifugation is then continued.
B) Following onset of deceleration you must wait until the
rotor has stopped. By opening and closing the lid you
reset the message "rotor". After entering a permissible
speed you can press start.
Display "OPEN" appears
although lid is closed
.
Will not start. Lid not properly closed
Open the lid and repeat locking procedure.
Message "Lid" appears
flashingly in the display. Drive stops.
Rotor stops without
deceleration to standstill.
Lid was opened manually during the run.
The instrument stops without deceleration. If you want to
continue the run, you must switch the instrument off and on
again.
Message "Lift Lid“
appears in the display Lid does not open
automatically. The lid has not been unlocked after release.
1. Avoid laying objects onto the centrifuge lid.
2. Lift the lid slightly.