517766
March 2003
- 28 -
33.
(00100001) Phase 1 – Water Valve Fault
The Module has detected a water valve fault.
Primary Source:
Water Valve connection
Action:
Check that both valves are connected up properly.
Secondary Source:
Water Valve coil faulty
Action:
1.
Check the valve coils are not open circuit.
2.
Replace Display Module if the valve coils are not faulty.
34.
(00100010) Phase 1 – Brake Resistor Fault
The circuit that controls the braking of the motor is faulty.
Primary Source:
Motor Controller
Action:
Replace Motor Controller
Secondary Source:
Display Module
Action:
Replace the Display Module
If the Display Module corrects the fault, then refit the original Motor Controller.
35.
(00100011) Phase 1 – MC Reset Error
The Display Module has sent a false signal to the Motor Controller.
Primary Source:
12 way Harness Connection.
Action:
Check the 12 way harness connection between the display Module
and the Motor Controller.
Secondary Source:
Display Module
Action:
Replace the Display Module.
36.
(00100100) Phase 1 to 6 - Water Leak Fault
The Motor Controller module has needed to top up the water level more than 4
times during agitate. This is excessive, as normally only one or two top ups are
required to replace the air that has escaped from a full load during agitate. The
most likely cause is that the machine is siphoning. The other alternative is that the
machine has developed a leak.
Primary Source:
Pump System.
Action
1)
Check the height of the drain hose outlet. Minimum 33.4 in (850mm),
Maximum 47 in (1200mm).
2)
Check that the hose guide is fitted and check that the hose does not
protrude more than (20mm) ¾ in beyond the guide.
Secondary Source:
Mechanical.
Action:
1)
Check the pressure tube connections on the Tub and Motor Controller
module.
2)
Check that the drive shaft seal and the pump housing seal have not
developed a leak.
Tertiary Source:
Motor Controller module.(Display Module Phase1)
Action:
Replace Motor Controller module.(Display Module Phase 1)
Содержание ecosmart GWL11
Страница 2: ...517766 March 2003 ...
Страница 21: ...517766 March 2003 21 17 WIRING DIAGRAM ...
