225
checking the tire inflation pressure using the
tire pressure gauge, turn the air compressor
switch off.
12.The sealant is injected into the tire when
the air compressor is switched on. After
the sealant is injected completely, wait
until the tire inflation pressure increases
to the specified tire inflation pressure.
For the correct pressure, check the tire
inflation pressure label on the driver's
door frame.
NOTE:
The inflation pressure may increase to about
43.5 psi (3 Bar) temporarily to inject the
sealant through the valve. Normally, the
inflation pressure decreases gradually and it
reaches the actual inflation pressure after
about 30 seconds.
13.Adhere the speed restriction sticker to an
area where it can be viewed easily by the
driver.
14.Adhere the repaired tire sticker to the
wheel of the flat tire.
Repaired Tire Sticker
15.When the tire inflates to the specified tire
inflation pressure, turn the air
compressor switch off, turn the sleeve of
the injection hose to the left, and pull it
out of the tire valve.
WARNING!
Never use the air compressor above 3 Bar
(43.5 psi). Using the air compressor at an
inflation pressure above 3 Bar (43.5 psi)
continuously is dangerous. If the air
compressor overheats, hot air will be
exhausted and you could get burned.
CAUTION!
If the tire inflation pressure does not
increase, repair of the tire is not
possible. If the tire does not reach the
specified tire inflation pressure within
10
minutes, it may have received exten
-
sive damage. In this case, the repair
using the tire service kit was not
successful.
Do not operate the air compressor for a
continuous 10
minutes or longer
because using it for long periods could
cause a malfunction.
WARNING!
Do not adhere the speed restriction sticker
to the padded area on the steering wheel.
Adhering the speed restriction sticker to
the padded area on the steering wheel is
dangerous because the air bag may not
operate (deploy) normally resulting in
serious injury. In addition, do not adhere
the sticker to areas where warning lights or
the speedometer cannot be viewed.