STARTING AND OPERATING
174
To temporarily cancel the system, use one of
these methods:
Slightly press the brake pedal.
Press the clutch pedal (if equipped with a
manual transmission).
Push OFF/CAN button.
If the RES (+) button is pushed when the
vehicle speed is 25
mph (40
km/h) or
higher, the system reverts to the previously
set speed.
NOTE:
If any of the following conditions occur, the
Speed Control system is temporarily
canceled:
The parking brake is applied.
Automatic Transmission:
the gear selector
is in the PARK or NEUTRAL position.
Manual Transmission:
the gear selector is
in the NEUTRAL position.
Automatic Transmission:
the Speed Control
cannot be canceled while driving in
manual mode (gear selector shifted from D
to M position). Therefore, engine braking
will not be applied even if the transmis
-
sion is shifted down to a lower gear. If
deceleration is required, lower the set
speed or press the brake pedal.
When the Speed Control system is tempo
-
rarily canceled, the speed cannot be reset.
RADAR SENSORS — IF
EQUIPPED
Rear Radar Sensors
The following systems use the rear radar
sensors:
Blind Spot Monitoring (BSM) System
Rear Cross Traffic Alert (RCTA)
The radar sensors function by detecting the
radio waves reflected off of a vehicle
approaching from the rear, or an obstruction,
sent from the radar sensor.
The radar sensors are installed inside the
rear bumper, one each on the left and right
sides.
Radar Sensor Locations
Always keep the surface of the rear bumper
near the radar sensors clean so that the radar
sensors operate normally. Also, do not apply
items such as stickers.
The detection ability of the radar sensors has
limitations. In the following cases, the detec
-
tion ability may be decreased, and the
system may not operate normally:
The rear bumper near the radar sensors
has been damaged.
CAUTION!
If the rear bumper receives a severe
impact, the system may no longer operate
normally. Stop the system immediately
and contact an authorized dealer.