FENIX IMVICO
SM3000 OPERATION MANUAL
NOTES
:
•
Use
paper rolls that meet the specifications indicated in this manual.
•
DO NOT
open the printer cover during the printing operation.
•
Close
the cover correctly, checking that the ‘PAPER OUT’ LED turns off.
3.2- CLEANIING A PAPER JAM
If a paper jam occurs, please proceed as indicated in the following steps:
1) Switch the printer off and press the button in order to try and open the lid.
2)
If the paper is jammed in the cutter, and you can not open the lid of the printer, you must
proceed as follows: first, it should open the front cover located in the central part of the
printer sliding downward; then, manually rolling gear coupled to the cutter blade, until
backwards to its original position (until you can easily lift the lid).
Warning
:
Never force the opening of the cover, as the cutter blade could bend and become
permanently damaged if the paper is jammed with it.
Fig. 3.2
- Manual cutter positioning.
3) Remove the jammed paper and any other remaining piece of paper. Install the paper roll in the
same way as indicated in the previous section.
3.3- BUTTONS AND SWITCH
3.3.1- Power supply switch
It is placed on the lower front of the printer and acts as the switch of the external power supply. The front
panel provides a ‘POWER’ LED that indicates whether the power is on.
3.3.2- Paper feed button (FEED)
The FEED button in the front panel activates the automatic paper feed.
The paper is feeding while the button is kept pressed. The FEED button functionality is not enabled in
the following conditions:
(1) The paper sensor does not detect paper.
(2) The cover is open.
(3) The
ESC c 5
command has been sent.
15/55
Manually rolling gear
coupled to the cutter
blade, until backwards
to its original position.
Open the front cover
sliding downward.
