![background image](http://html1.mh-extra.com/html/federal-signal-corporation/ultravoice-uv/ultravoice-uv_installation-operation-and-service-manual_3830688061.webp)
61
Options
Installation, Operation, and Service Manual
Converting the files
To convert the files, do the following:
1. Adjust the amplitude to insure that the peaks are at or slightly into the limits. If
converting from 16 bit to 8 bit, insure that dithering is disabled.
2. Activate the Digital Voice system by using the radio receiver or the siren
controller panel switches. To program activation codes with Digital Voice
Messages under them; follow the instructions in the programming software. It
is possible to assign codes to the functions DIG VOICE 1 through DIG VOICE
250. As in all sounding functions, the unit must first receive the ARM command
followed by one of the DIG VOICE commands to activate the stored message.
The Digital Voice Volume is adjustable through a potentiometer located on the
controller front panel, called DV Gain.
Installation of Other Manufacturers’ Radio Receivers
Improper installation of radio control equipment may cause the siren to
malfunction or operate intermittently. Installation must only be performed by
experienced radio technicians who have thoroughly read this manual.
1. TUNING—Tune the radio receiver to the manufacturer’s specifications.
2. POWER—Determine the radio power requirements. The UV+ control card panel
pr12 Vdc on the RADIO connector on the front panel, as shown below;
RADIO Connector, 8 pin MOD jack;
1. Receive Audio, 300 mV-3 V
p-p
2. Transmit Audio, 50 mV-3 V
p-p
3. Carrier Detect - active low
4. PTT- active low
5. +12 Vdc
6. GND
7. +12 Vdc
8. GND
Содержание ultravoice UV
Страница 42: ...42 Installation UltraVoice UV Figure 15 Omni Antenna Installation Example...
Страница 43: ...43 Installation Installation Operation and Service Manual Figure 16 Antenna Grounding...
Страница 71: ...71 Appendix C Drawings Figure 25 UV Controller Two way Radio Wiring Diagram...
Страница 72: ...72 Figure 26 UVTD IP Broadband Wiring Diagram...