![background image](http://html1.mh-extra.com/html/federal-signal-corporation/ultravoice-uv/ultravoice-uv_installation-operation-and-service-manual_3830688032.webp)
32
Installation
UltraVoice (UV)
5. Attach the UV controller to the wall, using four user-supplied 1/2 inch x 5 inch lag
bolts. Slide a user-supplied 1/2 inch flat washer onto each bolt before threading
the bolt into the pole.
6. Install a user-supplied, fused, disconnect switch. Use the proper type required by
the authority having jurisdiction in your area.
7. If the speaker array is installed on the roof of the building, it may be desirable to
install the UV controller inside the building, if practical.
Figure 9 Typical Siren
REFER
TO
SPEC
REFER
TO
SPEC
MOD6024B
RADIO ANTENNA (YAGI)
SPEAKER CABLE IN CONDUIT
TELEPHONE POLE
ANTENNA CABLE
WITH MAIN DISCONNECT
BATTERY CABINET
CONTROL CABINET
GROUND RODS (2 EACH) 8' MIN.
120VAC SINGLE-PHASE METER BASE
(Must meet local utility requirements)
291164D
TYPICAL SIREN
GROUND WIRE 4 AWG
REFER
TO
SPEC
1 " PIPE (1)
5
8
4'7.5"
REFER
TO SPEC
OPTIONAL AC TRANSFORMER
AND DC RECTIFIER
Содержание ultravoice UV
Страница 42: ...42 Installation UltraVoice UV Figure 15 Omni Antenna Installation Example...
Страница 43: ...43 Installation Installation Operation and Service Manual Figure 16 Antenna Grounding...
Страница 71: ...71 Appendix C Drawings Figure 25 UV Controller Two way Radio Wiring Diagram...
Страница 72: ...72 Figure 26 UVTD IP Broadband Wiring Diagram...