![background image](http://html1.mh-extra.com/html/federal-signal-corporation/ultravoice-uv/ultravoice-uv_installation-operation-and-service-manual_3830688031.webp)
31
Installation
Installation, Operation, and Service Manual
6. Drill a 3/8 inch pilot hole at each of the locations. Drill each hole at least 3-1/2 inches
(90 mm) deep.
7. Use a crane or mechanical hoist to lift the UV controller to the desired height along
the pole. Attach the UV controller to the pole, using four user-supplied 1/2 inch x
5 inch lag bolts. Slide a user-supplied 1/2 inch flat washer onto each bolt before
threading the bolt into the pole.
8. Attach the UV controller to the pole, using four user-supplied 1/2 inch x 5 inch lag
bolts. Slide a user-supplied 1/2 inch flat washer onto each bolt before threading the
bolt into the pole.
9. Mount a user-supplied fused disconnect switch on the pole beneath or beside the UV
controller.
See Electrical Connections.
Flat Surface Mounting
Post notices at all roof access points indicating a roof mounted siren is
installed and a potential of hearing damage exists.
It may be practical to mount the siren on a flat-roofed building, depending
on the location of the speaker array. When installing the siren on a flat roof,
always be sure that the loudspeakers clear parapets or other obstructions by
at least ten feet.
Total weight of the UV controller is listed in the Specifications section. Make sure that
the mounting surface and mounting method selected can safely sustain the weight of
the assembly and user-provided batteries. In addition, the mounting method used must
be able to withstand external mechanical stresses that may be applied to the assembly
(such as, applicable wind loads for the area). Consult building authorities in your area for
recommendations regarding local ground conditions and wind loads.
To install the UV controller to a flat surface, do the following:
1. Install the speaker array on the roof, following the instructions supplied with the
array.
2. Attach the template to the wall and mark the four mounting holes on the pole for
the primary UV controller.
3. Drill a 3/8 inch pilot hole at each of the locations. Drill each hole at least 3-1/2
inches (90 mm.) deep.
4. Use a lift to lift the UV controller to the desired height along the pole. Attach the
UV controller
to the wall, using four user-supplied 1/2 inch x 5 inches lag bolts.
Slide a user-supplied 1/2 inch flat washer onto each bolt before threading the bolt
into the pole.
Содержание ultravoice UV
Страница 42: ...42 Installation UltraVoice UV Figure 15 Omni Antenna Installation Example...
Страница 43: ...43 Installation Installation Operation and Service Manual Figure 16 Antenna Grounding...
Страница 71: ...71 Appendix C Drawings Figure 25 UV Controller Two way Radio Wiring Diagram...
Страница 72: ...72 Figure 26 UVTD IP Broadband Wiring Diagram...