![background image](http://html1.mh-extra.com/html/federal-signal-corporation/ultravoice-uv/ultravoice-uv_installation-operation-and-service-manual_3830688023.webp)
23
Operations
Installation, Operation, and Service Manual
Sensor Inputs (JP15)
Terminal block JP15 is located at the bottom of the backplane motherboard. Use sensor
inputs to detect and notify conditions occurring at an RTU location. See Figure 6.
Table 10 Sensor Connections
JP15 Terminal
Function
1—COM
Common
2—SPR #1
Spare #1
3—COM
Common
4—INTR
Intrusion
5—COM
Common
6—SOL
Solar
7—COM
Common
8—AC
AC Power
9—COM
Common
10—600 PTT
600 PTT
11—COM
Common
12—SPR #2
Spare #2
Spare 1 and 2 (JP15: pins 1 and 2)
Use for user-defined application.
Intrusion (JP15: pins 3 and 4)
Alerts the controller when one of the unit’s doors has been opened. Low is intrusion pass.
Solar (JP15: pins 5 and 6)
Use to sense operation of solar power system.
Jumper JP15: pins 5 and 6 when using solar. This jumper enables solar mode, which
causes the system not to report a failure during low-light conditions or at nighttime. This
is done by locking in a power pass until a master reset. For solar panel testing during the
day, initiate a master reset, wait 15 seconds, and then poll.
AC Power/Solar (JP15: pins 7 and 8)
Jumper JP15 pins 7 and 8 when using solar only. If using ac, 7 and 8 are connected to ac
power sensor.
600 ohm PTT (JP15: pins 9 and 10)
Shorting pins 9 and 10 puts the UV+ controller card in local PA mode.
User-Defined Application (JP15: pins 11 and 12)
Use spare JP15: pins 11 and 12 for user-defined application.
+5 Vdc Supply (JP16)
The UV+ backplane motherboard can 5 Vdc for external use up to 150 mA. See
Figure 7.
Содержание ultravoice UV
Страница 42: ...42 Installation UltraVoice UV Figure 15 Omni Antenna Installation Example...
Страница 43: ...43 Installation Installation Operation and Service Manual Figure 16 Antenna Grounding...
Страница 71: ...71 Appendix C Drawings Figure 25 UV Controller Two way Radio Wiring Diagram...
Страница 72: ...72 Figure 26 UVTD IP Broadband Wiring Diagram...