FCA US DODGE CHARGER RWD 2019, Руководство пользователя

Страница: 51 / 244

1. At the garage door opener motor (in the
garage), locate the “LEARN” or “TRAIN”
button. This can usually be found where the
hanging antenna wire is attached to the
garage door opener motor. Firmly push and
release the “LEARN” or “TRAIN” button.
2. Return to the vehicle and push the pro-
grammed HomeLink button three times
(holding the button for two seconds each
time). If the garage door opener motor oper-
ates, programming is complete.
3. Push the programmed HomeLink button to
confirm that the garage door opener motor
operates. If the garage door opener motor
does not operate, repeat the final steps for
the rolling code procedure.
Non-Rolling Code Garage Door Opener Final Steps
1. Push and hold the programmed HomeLink
button and observe the HomeLink indicator
light. If the HomeLink indicator light stays
on constantly, programming is complete.
2. Push the programmed HomeLink button to
confirm that the garage door opener motor
operates. If the garage door opener motor
does not operate, repeat the steps from the
beginning.
WARNING!
• Your motorized door or gate will open and
close while you are programming the uni-
versal transceiver. Do not program the
transceiver if people or pets are in the
path of the door or gate.
• Do not run your vehicle in a closed garage
or confined area while programming the
transceiver. Exhaust gas from your ve-
hicle contains Carbon Monoxide (CO)
which is odorless and colorless. Carbon
Monoxide is poisonous when inhaled and
can cause you and others to be severely
injured or killed.
Programming HomeLink To A
Miscellaneous Device
Refer to “Programming HomeLink To A Garage
Door Opener” for the procedure on how to pro-
gram HomeLink to a miscellaneous device, as it
follows the same procedure. Be sure to deter-
mine if the device has a rolling code, or non-
rolling code before beginning the programming
process.
NOTE:
Canadian radio frequency laws require transmit-
ter signals to time-out (or quit) after several
seconds of transmission, which may not be long
enough for HomeLink to pick up the signal
during programming. Similar to this Canadian
law, some U.S. gate operators are designed to
time-out in the same manner. The procedure
may need to be preformed multiple times to
successfully pair the device to your HomeLink
buttons.
49