FCA US DODGE CHARGER RWD 2019, Руководство пользователя

Страница: 24 / 244

• The Easy Entry/Easy Exit feature is disabled
when the driver seat position is less than
0.9 of an inch (22.7 mm) forward of the rear
stop. At this position, there is no benefit to the
driver by moving the seat for Easy Exit or Easy
Entry.
Each stored memory setting will have an asso-
ciated Easy Entry and Easy Exit position.
NOTE:
The Easy Entry/Exit feature is not enabled when
the vehicle is delivered from the factory. The
Easy Entry/Exit feature is enabled (or later dis-
abled) through the programmable features in
the Uconnect system. Refer to “Uconnect Set-
tings” in “Multimedia” in your Owner’s Manual
for further details.
Heated Seats — If Equipped
On some models, the front and rear seats may
be equipped with heaters located in the seat
cushions and seat backs.
WARNING!
• Persons who are unable to feel pain to the
skin because of advanced age, chronic
WARNING!
illness, diabetes, spinal cord injury, medi-
cation, alcohol use, exhaustion or other
physical condition must exercise care
when using the seat heater. It may cause
burns even at low temperatures, especially
if used for long periods of time.
• Do not place anything on the seat or seat-
back that insulates against heat, such as a
blanket or cushion. This may cause the
seat heater to overheat. Sitting in a seat
that has been overheated could cause se-
rious burns due to the increased surface
temperature of the seat.
Front Heated Seats
The front heated seat control buttons are lo-
cated within the climate or controls screen of
the touchscreen.
You can choose from HI, LO, or OFF heat set-
tings. The indicator arrows in touchscreen but-
tons indicate the level of heat in use. Two
indicator arrows will illuminate for HI, and one
for LO. Turning the heating elements off will
return the user to the radio screen.
• Press the heated seat button once to turn
the HI setting on.
• Press the heated seat button a second
time to turn the LO setting on.
• Press the heated seat button a third time
to turn the heating elements off.
If the HI-level setting is selected, the system
will automatically switch to LO-level after ap-
proximately 60 minutes of continuous opera-
tion. At that time, the display will change from
HI to LO, indicating the change. The LO-level
setting will turn off automatically after approxi-
mately 45 minutes.
NOTE:
• Once a heat setting is selected, heat will be
felt within two to five minutes.
• The engine must be running for the heated
seats to operate.
Vehicles Equipped With Remote Start
On models that are equipped with remote start,
the heated seats can be programmed to come
on during a remote start.
GETTING
TO
KNOW
YOUR
VEHICLE
22