WARNING!
• Take care to avoid the radiator cooling fan
whenever the hood is raised. It can start
anytime the ignition switch is ON. You can
be injured by moving fan blades.
• Remove any metal jewelry such as rings,
watch bands and bracelets that could
make an inadvertent electrical contact.
You could be seriously injured.
• Batteries contain sulfuric acid that can
burn your skin or eyes and generate hydro-
gen gas which is flammable and explosive.
Keep open flames or sparks away from the
battery.
1. Apply the parking brake, shift the automatic
transmission into PARK and place the igni-
tion in the OFF position.
2. Turn off the heater, radio, and all unneces-
sary electrical accessories.
3. If using another vehicle to jump start the
battery, park the vehicle within the jumper
cable’s reach, apply the parking brake and
make sure the ignition is OFF.
WARNING!
Do not allow vehicles to touch each other as
this could establish a ground connection and
personal injury could result.
Jump Starting Procedure
WARNING!
Failure to follow this jump starting procedure
could result in personal injury or property
damage due to battery explosion.
CAUTION!
Failure to follow these procedures could re-
sult in damage to the charging system of the
booster vehicle or the discharged vehicle.
Connecting The Jumper Cables
1. Connect the positive
(+)
end of the jumper
cable to the remote positive
(+)
post of the
vehicle with the discharged battery.
2. Connect the opposite end of the positive
(+)
jumper cable to the positive
(+)
post of the
booster battery.
3. Connect the negative
(-)
end of the jumper
cable to the negative
(-)
post of the booster
battery.
4. Connect the opposite end of the negative
(-)
jumper cable to the remote negative
(-)
post
of the vehicle with the discharged battery.
WARNING!
Do not connect the jumper cable to the nega-
tive (-) post of the discharged battery. The
resulting electrical spark could cause the bat-
tery to explode and could result in personal
injury. Only use the specific ground point, do
not use any other exposed metal parts.
5. Start the engine in the vehicle that has the
booster battery, let the engine idle a few
minutes, and then start the engine in the
vehicle with the discharged battery.
6. Once the engine is started, remove the
jumper cables in the reverse sequence:
Disconnecting The Jumper Cables
1. Disconnect the negative
(-)
end of the jumper
cable from the remote negative
(-)
post of
the vehicle with the discharged battery.
IN
CASE
OF
EMERGENCY
154
Содержание DODGE CHARGER RWD 2019
