Fayat DYNAPAC CX8, Инструкция по эксплуатации, Страница: 83 / 180

Operation
4812165801.pdf 2024-04-22
Fig. Display - Machine status
When starting and driving a machine that is cold,
remember that the hydraulic fluid is also cold and
that braking distances can be longer than normal
until the machine reaches the working temperature. When starting and driving a machine that is cold,
remember that the hydraulic fluid is also cold and
that braking distances can be longer than normal
until the machine reaches the working temperature.
The machine always starts in the Transport
position, without it being possible to use off-set,
vibration or sprinkling. The machine always starts in the Transport
position, without it being possible to use off-set,
vibration or sprinkling.
If the machine and drums are in off-set mode,
switch to work mode and reset before loading the
machine on a truck. This is indicated by a warning
in the display. If the machine and drums are in off-set mode,
switch to work mode and reset before loading the
machine on a truck. This is indicated by a warning
in the display.
Parking brake test
To be sure that the parking brake works and is in good
condition, perform following procedure daily.
Fig. Control panel
1. Rpm switch
2. Parking brake
3. Forward/Reverse lever
4. Speed limiter
4
3
1
2
Put the machine on flat ground.
Make sure that there are no obstacles in the
direction of travel, on the ground, in front of or
behind the roller, or overhead. Make sure that there are no obstacles in the
direction of travel, on the ground, in front of or
behind the roller, or overhead.
Activate the parking brake with the parking brake
button (2). Turn on the quick selection menu on the
display, the brake test button (5) is now visible in the
menu bar on the touch screen.
5
Fig. Display view
5. Brake test button
Set the engine speed (1) to medium or high speed and
set the propulsion speed limiter (4) to max., i.e. no
limitation.
Push the brake test button (5) in the touch screen on
the display and keep it pushed, a pop-up symbol (6)
shows on the screen when the button is activated.
NOTE! This activation is not possible to do from the
display controller knob.
71