Fayat DYNAPAC CX8, Инструкция по эксплуатации, Страница: 120 / 180

Operating instructions - Summary
4812165801.pdf 2024-04-22
Load carrier Load carrier
- When loaded, the vibratory roller is centered laterally on the platform (± 5 cm) and is loaded in
backward direction. - When loaded, the vibratory roller is centered laterally on the platform (± 5 cm) and is loaded in
backward direction.
- The parking brake is applied and in good working condition. - The parking brake is applied and in good working condition.
- The drums are placed on rubber friction pads (4) to achieve the static friction 0.6 between the
surfaces. - The drums are placed on rubber friction pads (4) to achieve the static friction 0.6 between the
surfaces.
- The contact surfaces must be clean, wet or dry, and free from frost, ice and snow. If there is a
risk of frost, ice and/or snow the platform has to be salted. - The contact surfaces must be clean, wet or dry, and free from frost, ice and snow. If there is a
risk of frost, ice and/or snow the platform has to be salted.
- The lashing mounts on the load carrier have MSL/LC/SWL at least 2 tonnes. - The lashing mounts on the load carrier have MSL/LC/SWL at least 2 tonnes.
Lashings Lashings
- The maximum securing load (MSL/LC/SWL) of the lashings (strap or chain) is at least 1.6
tonnes (1,600 daN) and the lashings are well pre-tensioned during the entire transport. - The maximum securing load (MSL/LC/SWL) of the lashings (strap or chain) is at least 1.6
tonnes (1,600 daN) and the lashings are well pre-tensioned during the entire transport.
- Each of lashings 1-3 is either one double or two single lashings. The double lashing is the
same lashing in a sling through a lashing eye or round a machinery part down in two different
lashing points on the platform. - Each of lashings 1-3 is either one double or two single lashings. The double lashing is the
same lashing in a sling through a lashing eye or round a machinery part down in two different
lashing points on the platform.
- Lashings in the same direction are placed in different lashing mounts on the trailer. Lashings
that are pulled in opposite directions may be placed in the same lashing mount, however. - Lashings in the same direction are placed in different lashing mounts on the trailer. Lashings
that are pulled in opposite directions may be placed in the same lashing mount, however.
- The lashings are as short as possible. - The lashings are as short as possible.
- The lashing hooks must not lose grip if the lashings become slack. - The lashing hooks must not lose grip if the lashings become slack.
- The lashings are protected against sharp edges and corners. - The lashings are protected against sharp edges and corners.
- The lashings are located symmetrically in pairs on the right and left sides. - The lashings are located symmetrically in pairs on the right and left sides.
108