Fayat DYNAPAC CX8, Инструкция по эксплуатации, Страница: 27 / 180

Technical specifications
4812165801.pdf 2024-04-22
Technical specifications
Vibrations - Operator station
(ISO 2631)
The vibration levels are measured in accordance with the operational cycle described in
EU directive 2000/14/EC on machines equipped for the EU market, with vibration switched
on, on soft polymer material and with the operator’s seat in the transport position. The vibration levels are measured in accordance with the operational cycle described in
EU directive 2000/14/EC on machines equipped for the EU market, with vibration switched
on, on soft polymer material and with the operator’s seat in the transport position.
Measured whole-body vibrations are below the action value of 0.5 m/s² as specified in Directive
2002/44/EC. (Limit is 1.15 m/s²) Measured whole-body vibrations are below the action value of 0.5 m/s² as specified in Directive
2002/44/EC. (Limit is 1.15 m/s²)
Measured hand/arm vibrations also were below the action level of 2.5 m/s² specified in the same
directive. (Limit is 5 m/s²) Measured hand/arm vibrations also were below the action level of 2.5 m/s² specified in the same
directive. (Limit is 5 m/s²)
Noise level
The noise level is measured in accordance with the operational cycle described in
EU directive 2000/14/EC on machines equipped for the EU market, on soft polymer
material with vibration switched on and the operator's seat in the transport position. The noise level is measured in accordance with the operational cycle described in
EU directive 2000/14/EC on machines equipped for the EU market, on soft polymer
material with vibration switched on and the operator's seat in the transport position.
Guaranteed sound power level, L
wA
105 dB (A) Guaranteed sound power level, L
wA
105 dB (A)
Sound pressure level at the operator's ear (cab), L
pA
85 ±3 dB (A) Sound pressure level at the operator's ear (cab), L
pA
85 ±3 dB (A)
During operation the above values may differ because
of the actual operational conditions. During operation the above values may differ because
of the actual operational conditions.
Electrical system
The machine is tested according to
ISO 13766-1:2018 and ISO 13766-2:2018.
Do not install or operate any tele/radio transmitter
equipment that do not comply with their applicable
EMC standards.
Slopes
Max 20° or 36% Max 20° or 36%
The recommended max slope angle is for a machine
that runs straight on hard, flat surface.
Unstable ground, vibration on, speed and steering the
machine can all cause the machine to topple at
smaller angles than specified here.
15