Fayat Dynapac CC1200 VI, Инструкция по эксплуатации, Страница: 139 / 201

Maintenance - 500h
4812313735.pdf 2018-12-28
1
Run the roller slowly until the oil plug (1) is positioned
as illustrated.
Unscrew the plug and check that the oil level reaches
up to the bottom of the hole. Top up with new oil if
necessary. Use oil as per the lubricant specification.
Clean the magnetic oil plug (1) from any metallic
residue, and refit the plug.
125
Remove the oil filter (4).
Collect any spillage.
Install the new filter.
Fit the drain plug (2) to the end of the hose.
Fill with fresh engine oil. See under the heading
lubricants, for the correct oil grade. Fit the filler cap (3)
and check that the oil level is correct using the dipstick.
Start the engine and allow it to idle for a few minutes.
During this time, check around the oil filter and drain
plug for leaks.
Switch off the engine, wait for a minute or so and then
check the oil level. Top up with more oil if necessary.
Drum - oil level
Inspection - filling
Fig. Drum vibration side
1. Oil plug