Fayat Dynapac CC1200 VI, Инструкция по эксплуатации, Страница: 133 / 201

Maintenance measures - 250 h
4812313735.pdf 2018-12-28
Check that the hose clamps between the filter
housing and the suction hose are tight and that
the hoses are intact. Inspect the entire hose
system, all the way to the engine.
119
Remove the oil filter (4).
Collect any spillage.
Install the new filter.
Fit the drain plug (2) to the end of the hose.
Fill with fresh engine oil. See under the heading
lubricants, for the correct oil grade. Fit the filler cap (3)
and check that the oil level is correct using the dipstick.
Start the engine and allow it to idle for a few minutes.
During this time, check around the oil filter and drain
plug for leaks.
Switch off the engine, wait for a minute or so and then
check the oil level. Top up with more oil if necessary.
Air cleaner
- Cleaning
Fig. Air cleaner
2. Cover
5. Filter housing
2
5
Wipe the inside of the cover (2) and filter housing (5).
Wipe clean on both sides of the outlet
pipe.
Outer edge of outlet
pipe.
Inner edge of
outlet pipe.
Wipe also both surfaces for the outlet pipe; see
adjacent figure.
Check that the hose clamps between the filter
housing and the suction hose are tight and that
the hoses are intact. Inspect the entire hose
system, all the way to the engine.