EN
EN
41
40
2. You are recommended to attach the electrodes surround the treatment area if you want to select
DMS function. The other DMS functions need to connect with four electrodes as below.
Make sure there is a linear path
between the two pads of each
channel. Follow up the "Appendix"
chapter (page 134) with all suggestions
regarding pads application
The four electrodes of channel A and
channel B stick to skin well, and in an
orderly fashion around a muscle.
The positive pole electrode of channel
A places at the central point and the
other three electrodes place around
the treatment area.
B
A
B
A
B
A
B
A
B
A
B
A
B
A
B
A
Such as:
Such as:
Such as:
3. When you stick only one channel electrodes (channel A or B) to use, you must set the DMS to .
If you set to other DMS functions, the broken circuit symbol
indicates that the resistance is
too high and you should connect with four electrodes.
4. When the four electrodes are not attached to surround the area, you should set the DMS to or
.
6) Selecting the correct intensity level
(1 Low-30 High)
When you start a program, you must increase the
intensity level so that the stimulation can start. To
do this, press
and
buttons for the rel-
evant channels until the desired setting is reached.
The intensity levels are shown by the level scales
bar graphs.
When the program is starting, the treatment time is
shown and entering countdown.
When the program is finished the intensity auto-
matically returns to 0, and the timer change to program number.
• If the stimulation levels are uncomfortable or become uncomfortable, reduce the
stimulation intensity to a comfortable level and contact a doctor if problem persists.
•
If your pain does not improve and you become sore from over-use, refrain from treating
those areas for two (2) days. If this issue reoccurs, reduce the treatment time and intensity
settings for future treatment, contact a doctor.
•
If you feel pain, dizziness, discomfort or nausea, during or after the treatment, call a doctor.
7) Turn off the device
After finishing the treatment, you can press the
button and hold for above 2 seconds to
switch off the device. If there is no operation in the panel for three 3 minutes in the waiting state,
the device will switch off automatically.
8) Remove the pads from your skin
• Turn off the device, then remove the pads from your skin softly and place them back on the pro-
tective plastic film.
• Take off the pads from wires.
• Unplug wires from the device.
Don’t remove the pads before you turn off the device.
9)
Safety Lock Feature
The lock function automatically activates after
there is no operation in the panel for 30 seconds,
and will be indicated by the
display on the
LCD. This is a safety feature to prevent accidental
changes to your settings and to prevent accidental
increases the output intensity level.
Press
buttons of each output to unlock.
Fig. 9
Fig. 10
