EN
EN
33
32
Discover M-Coach, you will find systematic information of treatment or training, including modes,
programs, right electrodes placement, the post of training, suggested using time, suggested using
plan, etc., M-Coach will guide you use the unit easily.
Minimum requirement: iOS 8.0 and Android™ 5.0.
M-coach is an app that can be downloaded for free from App Store™ or from Google Play Store™.
This is an additional support that integrates the information contained in these instructions for use,
providing indications and suggestions for making the best use of this device and thus achieving
the set objectives. The app helps to use the device and provides information on the programs
contained in the device, on the correct positioning of the electrodes and on the methods of use.
You should add your device to the APP the first time you use M-Coach.
1. Click the M-Coach icon to turn on the APP.
2. Click the Scan icon to add your device to the APP by scanning the QR code on the back of the
device.
3. When device added successfully, the APP will automatic memory device. If you want to switch
other devices, please set the “Switch device” function in “Me” mode.
IMPORTANT SAFETY PRECAUTIONS AND WARNINGS
INTRODUCTION
When should the device be used?
Use as soon as your pain begins. Start with a short. It is better to get pain under control sooner so
it does not reach such a high pain threshold that it limits your daily activities.
Setting the intensity
Intensity is based upon your level of comfort. Begin the first session with a low intensity and a
short duration while learning how to operate the device. Therefore, caution should be used when
working with maximum intensities. Do not exceed your comfort level.
How long should you use the device?
It is recommended that you use the device once a day (up to 30 minutes) for each reatment area.
Depending on your pain level, you may need to use it longer. Do not exceed 3 times a day (ma-
ximum 90 minutes total).Start with one session. Always turn unit off with pads still adhered to
skin. Rate your pain to check your progress, 1 low to 30 high. Intensity is based upon your level
of comfort. Begin the first session with a low intensity and a short duration while learning how to
operate.
Stop the therapy session if pain has reduced or stopped. If your pain does not improve and you be-
come sore from over-use, refrain from treating those areas for 2 days. If this issue reoccurs, reduce
the treatment time and intensity settings for future treatment.
When to stop using the device?
1) If you experience an adverse reaction — skin irritation / redness / burns, headache or other pain-
ful sensation — or if you feel any unusual discomfor
2) If your pain does not improve, becomes seriously chronic and severe, or continues for more than
5 days.
If you feel pain, dizziness, discomfort or nausea, consult a doctor.
What type of pain is TENS best for?
This therapy works best on acute pain because it is localized. Acute pain occurs in one area for less
than 3 months. If you have chronic pain, you may have pain in more than one area and for longer
than 6 months. Chronic pain may be compounded by other issues that this device cannot address.
Remember this device does not cure your pain or the original cause of the pain. It provides tempo-
rary relief or reduction of pain.
APPLIANCE PREPARATION
1) INSERTING THE BATTERIES
This appliance operates on three replaceable AAA 1.5 V alkaline batteries (not provided).
• To insert the batteries, open the battery compartment on the back of the device (Fig. 3).
• Insert the batteries as indicated, then close the battery compartment.
2) ATTACH PADS TO THE LEAD WIRE
• Each wire has two leads with pin-inserted connectors.
• Insert the lead wire connector into electrodes connector.
• Make sure no bare metal is exposed.
3) INSERT LEAD WIRE INTO THE UNIT
Before proceeding to this step, be sure the device is completely turned OFF.
• Hold the lead wire plug and insert it into the socket on the top of the stimulator (Fig.5).
• The device has 2 independent channels A,B.
• Make sure which channel you want to use before you connect wires to the device.
Fig. 3
Fig. 4
Fig. 5
INSTRUCTIONS FOR USE
1) Pad placement
Remove the clear plastic film from the back of the pads.Place pads on clean, dry and healthy skin,
near or surrounding the area with pain at least 2 cm apart, and do not let them touch. Make sure
there is a linear path between the two pads. See Applications Manual for further information.
Make sure the device is turned off before placing pads on skin.
Never remove the self-adhesive electrodes from the skin while the device is turned on.
Note: The cable has gray line and white line. The gray line is positive pole and the white is
negative pole.
