Fantic Motor TL 250, Руководство по ремонту

Страница: 40 / 138

40
CHAPTER 12
BRAKE
ADJUSTMENT
40
12.5 HEADLIGHT BEAM
12.6 CARBURETTOR
Slow jet 45
Main jet 70
Choke jet 42
Float level 12 mm
WORKSHOP MANUAL
TL 250
• The headlight beam is adjusted by hand
• The height of the beam should be checked at regular intervals.
It can be adjusted vertically only.
• Place the vehicle (parallel to the ground, but not on its stand)
10 m from a vertical surface
• Measure the height from the centre of the headlight to the
ground and mark the wall with a cross 9/10 of this height up
the wall
• Turn on the headlight set to dipped, sit on the bike, and
check that the beam shining on the wall is just under the cross
marked on the wall.
12.6.1 IDLING (adjusting idling speed)
NOTE: Perform this adjustment while the engine is warm.
• Connect a rev counter.
• Start the engine and run it steadily at a speed of between 1250
and 1550 rpm, turning the screw illustrated in the figure (BC)
accordingly.