Fantic Motor TL 250, Руководство по ремонту

Страница: 15 / 138

15
WORKSHOP MANUAL
TL 250
CHAPTER 4
SPARE
PARTS

Use only original Fantic Motor spare parts; for all lubrication needs, use Fantic Motor-recommended grease and oil.
While other makes of product may look similar and do the same job, their quality may be inferior.
!
GASKETS, OIL SEALS AND O-RINGS
- When performing general repair work on the engine, replace all gaskets, O-rings and oil seals. In addition, clean all
mating surfaces and the edges of seals and O-rings.
- Prior to reassembly, lubricate mating parts and bearings with oil. Apply grease to the lips of seals.
WASHERS, LOCK PLATES AND COTTER PINS
When removing washers, lock plates and cotter pins, replace them with new parts. Locking tabs must be bent against
the surfaces of the relevant nut or bolt once they have been tightened correctly.
BEARINGS AND OIL SEALS
- Fit bearings and oil seals with the part numbers or brand markings facing out, namely turned to the visible side.
When installing oil seals, smear their lips with a fine coating of lithium grease.
- To avoid damaging the rolling surfaces, do not dry bearings with compressed air.
CIRCLIPS
- Check all circlips before fitting them. Always replace any circlips that have to be removed.
- Replace misshapen circlips when installing a new circlip.
- Check that the flat edge is on the opposite side to the point where pressure is applied.