Falcon G2844F, Инструкция по установке, обслуживанию и эксплуатации

Страница: 7 / 28

7
4. Heat Demand Indicator
This indicator will illuminate when thermostat demands heat, i.e. oil temperature is more than 5
⁰
C below the
temperature setting.
The indicator will extinguish when desired setting is reached.
5. Burner Lock-Out Indicator
Indicates flame failure (burner is not lit).
Filtration Pump Switch (2845F only )
(See Figure 4.)
Energises filtration pump when burner switch is in OFF (O) position.
Temperature Safety Limiter Reset Button
(See Figure 4.)
Inside red recess.
B B
A A
Key to Controls
A. Drain Valve
B. Access Plate
C C
C. Temperature Limit Device
D. Burner switch
E. Burner lockout reset switch
F. Burner lockout reset switch
D D
and indicator (G2844/F only)
G. Filtration pump switch E F
G G
G2845F G2844F
Figure 4
– G2844 & G2845 - Additional Controls
2.4.3 G2844F/G2845F
- Additional Controls
(See Figure 4)
The following additional controls are located behind cabinet door.
1) Burner and Temperature Controls ON/OFF Switch
Cuts power to burner and temperature controls.
2) Burner Lockout Indicator
Indicates flame failure.
2.5 PRE-COMMISSIONING CHECK
1) Clean out pan thoroughly using hot water and detergent. Rinse out and dry thoroughly.
Note
For further detail with regard to cleaning, refer to Section 8.
2) Ensure drain valve is closed. Fill pan with clean cooking oil to -MIN-
(maximum cold fill mark) indicated
on basket hanging rail. (See Figure 6). Note : -MAX- refers to maximum hot fill mark.
3) With gas supply still shut off, turn on electrical mains supply.
4) Open door and press temperature limit thermostat reset button
(red) , refer to Section 2.6. Set burner switch
to Position 'I' (ON position) .
5) Turn control knob to desired temperature (140
⁰
C) (G2845 only) . Heat demand indicator will illuminate (Figure
2, item 4).