Falcon G2844F, Инструкция по установке, обслуживанию и эксплуатации

Страница: 17 / 28

17
6.2.1 Lighting Instructions
Remove lid (if fitted) and baskets and set these aside. Ensure fryer pan is clean and completely dry. Ensure also that
drain valve is closed. Pour clean, cold oil to -MIN- pan level mark on basket hanging rail.
Note: If you are in the fat melting cycle <<fat melting cycle>> (FMC) and loading solid fat for the first time,
always remove basket support plate as detailed in Section 9. Solid fat should be in direct contact with fryer pan.
Refer to Section 9.
Warning:
Do not select any setting other than FMC when using solid fats as this will trip safety thermostat or in the
worst case scenario, ignite liquefied oils.
6.2.1.1 G2845F Model Only ( for switch locations , see figure 4 )
a) Ensure pan is filled with solid/shortening to indicated level and gas supply is established.
b) Ensure burner switch is in off position (O) .
c) Press burner switch to on position (1) .
d) Turn knob to select temperature.
(If solid fat is used - Select FMC fat melt cycle)
e) Heat on indicator will illuminate.
f) If burner fails to light, lock-out indicator will illuminate.
g) Reset burner by turning control knob to off position. Press lock-out switch ( Fig 4, E) and wait 30 seconds then repeat
from Step d).
h) If burner repeatedly fails to light, switch off electrical and gas supplies. Call service engineer.
Warning:
Do not select any setting other than FMC when using solid fats as this will trip safety thermostat or in the
worst case scenario, ignite liquefied oils.
6.2.1.2 G2844F model only ( for switch locations , see figure 4 )
a) Ensure pan is filled with solid/shortening to indicated level and gas supply is established.
b) Ensure burner switch is in off position (O) .
c) Press burner switch to on position (1) .
d) G2844 - Factory preset for a temperature of 180
⁰
C
(See Section 6.3 for instructions for change set temp) .
e) Display will illuminate with figures 8888 for 2 secs, CTT for 2 secs, r 06 for 2 secs and then displays Louu .
Heat demand LED indicator will illuminate.
f) If burner fails to light, lockout reset indicator will illuminate.
g) Wait 30 seconds and reset burner by pressing lock-out reset switch.
h) If burner repeatedly fails to light, switch off electrical and gas supplies and call a service engineer.
6.2.2 Operating Instructions
6.2.2.1 G2845F Models Only - Manually Operated
When unit has been lit as above, fryer may be operated as following:
a) If using solid fat, turn control knob clockwise to select FMC (Fat Melt Cycle) .
b) When solid/shortening has liquified, select desired
temperature.
Warning: Do not select any setting other than FMC when using solid fats as this will trip safety
thermostat or in worst case scenario, ignite liquefied oils.
c)
Fat or oil temperature will then be governed by controller to desired set temperature, selected by user.