Chapter 2 - page 4
MCO-TCO work mode
The auxiliary screen for the CO operating mode may be customized entirely (see "Screen
customizing" in the installation manual).
The one supplied by Fagor contains the following information:
1.- Clock
2.- This window can display the following data:
SBK
when the Single Block mode of execution is selected.
DNC
when the DNC mode is active.
P.....
number of the program selected.
Message
«In Position» - «Execution» - «Interrupted» - «RESET»
PLC messages
3.- The CNC messages are shown in this window.
4.- In manual operating mode this window does not display any data, but during execution, it shows
the lines of the program being executed.
5.- The axes have the following fields:
COMMAND
States the coordinate programmed, that is, the position that the axis must
reach.
ACTUAL
States the actual coordinate or actual position of the axis.
TO GO
States the distance that the axis has still to go to reach the coordinate
programmed.
FOLLOWING ERROR Difference between the theoretical and real values of the position.
The spindle (S) has the following fields available:
THEORETICAL
theoretical speed S programmed.
RPM
speed in rpm.
M/MIN
speed in meters/ minute.
FOLLOWING ERROR When operating with spindle guided stop (M19) this indicates the
difference between theoretical and real speeds.
The auxiliary axes only show the actual position of the axis
