Chapter 4 - page 5
MCO-TCO work mode
4.4 ERASING A PART-PROGRAM
To erase a part-program follow these steps:
* Press
to access the list of part-programs stored.
* Use the pointer to select from the left-hand column the part-program to be erased.
* Press
At the bottom the CNC will display a message requesting confirmation of the erasing
operation.
If you press
the CNC will erase the program selected and update the list of part-
programs stored.
If you press
the program will not be erased and the erasing operation is left.
4.5 COPY A PART-PROGRAM IN ANOTHER
To copy a part-program in another take the following steps:
* Press
to access the list of part-programs stored.
* Use the pointer to select in the left-hand column the part-program to be copied.
* Press
At the bottom the CNC will display a message requesting the number to be assigned to the
copy.
* Type in the program number required and press
This must be a number between 1 and 899999, and both numbers can be used.
* If there is already a part-program with said number, the CNC will display a message at the
bottom, asking if this should be replaced or if you wish to cancel the operation.
If you press
the CNC will ask for a new program number
If you press
the CNC will erase the present program and carry out program copying.
* The CNC requests the comment to be associated with the new part-program (with the copy).
A comment does not have to be associated.
* Press
or
The CNC updates the list of part-programs stored.
