Extron electronics IN1608 xi IPCP MA 70, Руководство пользователя

Страница: 25 / 144

IN1608 xi Scaling Presentation Switcher • Installation 17
Output Connections
100-240V ~ 1.3 A MAX
1
2
CONFIGURABLE
HDMI HDMI
5
6
7
8
1C
RS-232 IR
RS-232 IR
Tx Rx Tx Rx G
Tx Rx Tx Rx G
Tx Rx Tx Rx G
HDMI
1A
1B
3
4
INPUTS OUTPUTS
Tx Rx
RS-232
G
LAN
2x25W(8Ω)/2x50W(4Ω)
RESET
AUDIO INPUTS
OUTPUTS
REMOTE
L L 1 R R
L 2
R
L
3
R
CLASS 2 WIRING
L 4
R
L 5 R
+48V
+48V
1 2
L R
VARIABLE
IN1608 xi SA
2
MIC/LINE
L 6
R
SIG LINK
DTP IN
SIG LINK
DTP IN
SIG LINK
OUT
50/60 Hz
RS-232 IR
OVER DTP
OVER DTP
OVER TP
AMPLIFIED OUTPUT
DTP
HDBT
A B C D
E
A
DTP output and corresponding RS-232/IR
Over TP connector — Output C
B
HDMI output connectors
— Outputs A
and B
C
Analog audio output connectors
D
Amplified audio output
connector
E
TP output mode selection
switch
Figure 11. Output Connectors (IN1608 xi SA Example)
A
DTP output connector — Depending on the selected mode (DTP or HDBaseT),
connect either a DTP receiver or an HDBaseT-compatible output device to the RJ-45
OUT connector (see
Twisted Pair Recommendations for DTP and HDBaseT
Communication on page 24). The DTP output signal can travel up to 330 feet
(100 meters) without a loss of signal integrity.
Signal Support
DTP Mode HDBaseT Mode
• HDCP-compliant digital video
• Re-embedded program audio into the
TMDS output or analog audio
• DTP standard RS-232 and IR
pass-through signals on the associated
5-pole captive screw connector
•
Remote power to a DTP receiver
• Ethernet insertion of RS-232 control
signals onto the cable that carries
video and audio to extend them to the
Over TP port on a connected endpoint
(source or sink).
• HDCP-compliant digital video
• Re-embedded program audio into
the TMDS output
• RS-232 and IR pass-through signals
on the associated 5-pole captive
screw connector
•
Ethernet insertion of RS-232 control
signals
ATTENTION:
• Do not connect this connector to a computer or telecommunications network.
• Ne connectez pas ce port à des données informatiques ou à un réseau de
télécommunications.
• DTP remote power is intended for indoor use only. No part of the network that
uses DTP remote power should be routed outdoors.
•
L’alimentation DTP à distance est destiné à une utilisation en intérieur
seulement. Aucune partie du réseau qui utilise l’alimentation DTP à distance ne
peut être routée en extérieur.
•
Signal LED
— Lights when the scaler is sending a signal.
•
Link LED — Lights when a valid link is established.