Extreme Networks ExtremeWare XOS 11.1, Руководство пользователя

Страница: 386 / 496

Interior Gateway Protocols
ExtremeWare XOS 11.1 Concepts Guide
386
Areas
OSPF allows parts of a network to be grouped together into areas . The topology within an area is
hidden from the rest of the AS. Hiding this information enables a significant reduction in LSA traffic
and reduces the computations needed to maintain the LSDB. Routing within the area is determined
only by the topology of the area.
The three types of routers defined by OSPF are as follows:
●
Internal router (IR)—An internal router has all of its interfaces within the same area.
●
Area border router (ABR)—An ABR has interfaces in multiple areas. It is responsible for exchanging
summary advertisements with other ABRs.
●
Autonomous system border router (ASBR)—An ASBR acts as a gateway between OSPF and other
routing protocols, or other autonomous systems.
Backbone Area (Area 0.0.0.0)
Any OSPF network that contains more than one area is required to have an area configured as area
0.0.0.0, also called the
backbone . All areas in an AS must be connected to the backbone. When designing
networks, you should start with area 0.0.0.0 and then expand into other areas.
NOTE
Area 0.0.0.0 exists by default and cannot be deleted or changed.
The backbone allows summary information to be exchanged between ABRs. Every ABR hears the area
summaries from all other ABRs. The ABR then forms a picture of the distance to all networks outside of
its area by examining the collected advertisements and adding in the backbone distance to each
advertising router.
When a VLAN is configured to run OSPF, you must configure the area for the VLAN. If you want to
configure the VLAN to be part of a different OSPF area, use the following command:
configure ospf vlan <vlan-name> area <area-identifier>
If this is the first instance of the OSPF area being used, you must create the area first using the
following command:
create ospf area <area-identifier>
Stub Areas
OSPF allows certain areas to be configured as stub areas . A stub area is connected to only one other area.
The area that connects to a stub area can be the backbone area. External route information is not
distributed into stub areas. Stub areas are used to reduce memory consumption and computational
requirements on OSPF routers. Use the following command to configure an OSPF area as a stub area:
configure ospf area <area-identifier> stub [summary | nosummary] stub-default-cost
<cost>