Extreme Networks ExtremeWare XOS 11.1, Руководство пользователя

Страница: 434 / 496

Troubleshooting
ExtremeWare XOS 11.1 Concepts Guide
434
●
The devices at both ends of the link are powered-up.
●
Both ends of the Gigabit link are set to the same autonegotiation state.
The Gigabit link must be enabled or disabled on both sides. If the two sides are different, typically
the side with autonegotiation disabled will have the link LED lit, and the side with autonegotiation
enabled will not be lit. The default configuration for a Gigabit port is autonegotiation enabled. Verify
by entering the following command:
show ports configuration
On power-on, some I/O modules do not boot:
Check if you are using 110V power input. The BlackDiamond switch powers-up only four Input/
Output (I/O) modules if it is connected to a 110V outlet.
Error LED on the Management Switch Fabric Module (MSM) turns amber:
Check the syslog message for a “critical” software errors.
Status LED on the I/O module turns amber:
Check the syslog message for a related I/O module error. If the error is an inserted I/O module that
conflicts with the software configuration, use one of the following commands to reset the slot
configuration:
clear slot
configure slot <slot> module <module_type>
Otherwise, contact Extreme Networks Technical Support for further assistance.
ENV LED on the MSM turns amber:
Check each of the power supplies and all of the fans. Additionally, you display the status in the
show
power
and
show fans
displays.
Switch does not power up:
All products manufactured by Extreme Networks use digital power supplies with surge protection. In
the event of a power surge, the protection circuits shut down the power supply. To reset the power,
unplug the switch for 1 minute, plug it back in, and attempt to power-up the switch.
If this does not work, try using a different power source (different power strip/outlet) and power cord.
Using the Command Line Interface
The initial welcome prompt does not display:
Check that:
●
Your terminal or terminal emulator is correctly configured
●
Your terminal or terminal emulator has the correct settings:
■
9600 baud
■
8 data bits
■
1 stop bit