6) Operating panel
6) Operating panel
Inverter control, parametrization, operating-parameter display and
inverter-status information are all done through the operation
panel. This consists in seven segment, 4-digit display, six button
keypad field and 4-LED status line.
The adjacent picture shows the standard ve sion:
r
7-segment display, status LED and keypads
An optional build-in potentiometer is available
7-segment display:
The content of the display can be configured, to show different
operating parameters, while inverter in STOP or START mode,
error messages, parameters and parameter values (for
configuration see chapter: Parameter group 100 – BASIC parameter)
The
key is used to cycle through all programmed
content, including configuration parameter level.
(Configuration parameter on display have always a leading
F
).
Faults are displayed with the respective error code.
Flashing numbers in STOP mode indicate the target-frequency,
which the inverter will reach after START command is given.
Status LED:
To display the inverter status:
Inverter in START mode.
The display shows the
programmed working
parameters
To indicate the rotating
direction
Toggle with key
ON: single step modus is
selected for parameter
cycling
OFF:parameter group
cycling
ON, if the value on the
display corresponds to
output frequency
Keys and functions
Cycling through
different display
content
START command
STOP command
Toggle
switch for
ERROR RESET
Parameter:
Selection, and save
Increment /
Decrement Key
E800 – Rev.01 -EN-SOFT Rev. 2.04
© 2015 EURADRIVES EUROPE GmbH
- 29 -
